DAEWOO 40DM53FA1 40 Inch Android TV User Guide
- June 10, 2024
- Daewoo
Table of Contents
QUICK START GUIDE
Insert the batteries into the Remote Control
The remote may have a screw that secures the battery compartment cover onto the remote control {or this may be in a separate bag). Remove the screw, if the cover is screwed on previously. Then remove the battery compartment cover to reveal the battery compartment. Insert two 1.5V – size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back on. Secure the cover again with the screw, if any.
Connect the antenna to your TV
** 3. Connect the TV to the mains socket**
4. Switch the TV on
After plugging the power cord to the mains socket outlet the TV will switch on
automatically. If the TV is in standby mode the standby LED lights up.
To switch on the TV from standby mode either;
- Press the Standby button on the remote control.
- Press the centre of the control switch on the TV in.
Initial Setup Wizard
When turned on for the first time, “Welcome” message will be displayed along with the language selection options listed on the screen. Select the desired language from the list and press OK to continue.Follow the on-screen instructions to complete the initial setup process. Use the directional buttons and the OK button on the remote to select, set, confirm and proceed. Note: For detailed information and instructions on the initial setup process refer to the lnsruction Book of this TV
Change the Input Source
If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making any connection. Use a suitable cable to connect two units together. Once you have connected external systems to your TV, you can switch to different input sources. Press the Source button on your remote control consecutively or use the directional buttons and then press the OK button to switch to different sources when in Live TV mode. Besides this, you can switch to the desired input source by selecting the desired option from the Inputs menu on the Home Screen or TV options >Source menu in Live TV mode.
Connect your TV to the Internet
You can access the Internet via your TV, by connecting it to a broadband
system. It is necessary to configure the network settings in order to enjoy a
variety of streaming content and internet applications. These settings can be
configured from the Network and Internet menu located under the TV
Options>Settings menu in Live TV mode or under the Settings menu on the Home
Screen. You can also highlight the Connected/Disconnected icon on the Home
screen and press OK to access this menu. Wired Connection Connect your TV to
your modem/router via an Ethernet cable. There is a LAN port on the rear side
of your TV. The status of the connection under the Ethernet section in the
Network and Internet menu will changed from Not connected to Connected.
Wireless Connection A wireless LAN modem/router is required to connect the TV
to the Internet via wireless LAN. Highlight Wi-Fi option in the Network and
Internet menu and press OK to enable wireless connection. Available networks
will be listed. Highlight your network from the list and press OK to connect.
You may be asked to enter a password to connect to the selected network, in
case the network is password protected.
Wireless Connection Wired Connection
Documents / Resources
|
DAEWOO 40DM53FA1 40 Inch Android
TV
[pdf] User Guide
40DM53FA1 40 Inch Android TV, 40DM53FA1, 40 Inch Android TV, Android TV, TV
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>