SelectBlinds Modern Woven Motorized Roller Shades with Cassette Installation Guide
- June 10, 2024
- SelectBlinds
Table of Contents
SelectBlinds Modern Woven Motorized Roller Shades with Cassette
Product Information
Motorized Roller Shades
The motorized roller shades are designed for easy installation and use. The shades come with brackets that offer multiple methods of installation, including top-fixing and face-fixing. The shades are available in two styles – with a cassette or an exposed roll. The controls can be positioned as per the customer’s request during the ordering process. Additionally, the controls can be removed easily for any necessary adjustments.
Installation
Installation Guide for Motorized Roller Shades with Cassette
- Determine the installation method – top-fixing or face-fixing.
- Install the brackets as per the chosen method. Make sure that the position of the outermost brackets is at least 5cm away from the ends of the rail, with any other brackets evenly distributed across the width.
- Holding the rail at an angle, situate the T-shaped lip on the top of the cassette into the front lip of the bracket.
- Twist the back of the cassette upwards until it snaps into place against the back lip of the bracket.
Installation Guide for Motorized Roller Shades with Exposed Roll
- Determine the installation method – top-fixing, face-fixing, or side-fixing. Top-fixing or face-fixing is recommended for most installations, whereas side-fixing is only recommended if the width given during ordering was taken right at the top of the recess.
- Install the brackets as per the chosen method.
- Prior to fixing the brackets, remove the controls by unplugging them from the tube if any necessary adjustments are required.
- Locate the depression end (the opposite end to the controls) of the blind into the cross-shaped hole in the corresponding bracket.
- Lift the control end of the blind and slot the rectangular ‘lugs’ into the corresponding slots on the bracket.
By following these installation instructions, you can easily install and use the motorized roller shades with cassette or exposed roll for a convenient and comfortable experience.
Fitting the brackets
The brackets offer two methods of installation:
Top-Fixing
- Use the front two holes in the top of the bracket to fix to the lintel (the ‘ceiling’ of the recess).
Face-Fixing
- Use two screws through the back plate to mount onto a facing surface (a wall or window frame)
Note that the position of the outermost brackets should be at least 5cm away from the ends of the rail, with any other brackets evenly distributed across the width.
Fitting the shade
- Holding the rail at an angle, situate the T-shaped lip on the top of the cassette into the front lip of the bracket.
- Twist the back of the cassette upwards until it snaps into place against the back lip of the bracket.
Before you begin
- We will have positioned the controls where you requested during the ordering process. However if you decide to swap the side that they are on, direction of the roll or need to trim the blind further, the controls can be removed by simply unplugging them from the tube. This should be done prior to fixing the brackets.
Fitting the brackets
- The brackets offer three methods of installation:
Top-Fixing
- Where the brackets are screwed into the lintel (or ‘ceiling’ of the recess)
Face-Fixing
- Where the brackets are screwed onto a facing surface (a wall or window frame)
Side-Fixing
- Where the brackets are screwed into the side walls of the recess
Top Tip
Top-fixing or face-fixing are recommended for most installations, whereas side-fixing is only recommended if the width you gave us was taken right at the top of the recess.
Fitting the blind
- Locate the depression end (the opposite end to the controls) of the blind into the cross-shaped hole in the corresponding bracket.
- Lift the control end of the blind and slot the rectangular ‘lugs’ into the corresponding slots on the bracket.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>