MIPRO MI-580R 5.8 GHz Digital Stereo Bodypack Receiver User Guide

MIPRO MI-580R 5.8 GHz Digital Stereo Bodypack Receiver User Guide

I. Parts Name

1. AF OUT: 3.5 mm Stereo Earphone Jack
2. VOL: Power Switch and Volume Control
3. Receiving Antenna: Don’t cover them during operation to ensure the signal receiving.
4. LCD Screen: Display parameter status.
5. ▲ Button / ▼ Button : To increase / decrease or select settings.
6. MODE Button: Select functions and confirm.
7. ACT Sync Window
8. Battery Compartment: Insert one 18500 lithium battery or two AA batteries following the polarity indicator.
9. Battery Cover Hooks
10. Battery Compartment Cover: To prevent accidental operation of the MODE button.
11. USB Type-C Charging Port and Charging Indicator
12. Belt Clip

II. Battery Insertion and Replacement

1. Battery Insertion:
   (A) Press the battery cover side hooks 0 inward to lift the battery cover.
   (B) Insert one 18500 lithium battery or two AA batteries.
   (C)18500 lithium battery insertion: + pole faces toward left.
   (D)AA batteries insertion: insert one into the lower holder with + pole toward left, and then insert another into the upper holder with – pole toward left.

2. Check battery polarity was inserted correctly if battery power is sufficient but unable to turn on the transmitter.

3. Power off to conserve battery power. Remove the battery when it will not be used for an extended period of time.

4. This device can charge only one ICR-18500 lithium battery via USB Type-C. Cautions during charging:
   (A) Before charging, make sure the battery inside is an ICR-18500 lithium battery.
   (B)Confirm the battery is inserted with the correct polarity.
   (C)Turn off the power first and then charge.
   (D)This device has a safety measure to identify battery type but can only charge ICR-18500 lithium batteries.
   (E) This device can operate without a battery when using external power via USB Type-C.
   (F) Do not remove the lithium battery during charging status. Detach the charging cable before removing the lithium battery.
   (G)Check whether the 18500 lithium battery is inserted correctly or not if the indicator doesn’t glow.
   (H)indicator: Red (charging); Green (full)

Ill. Operating Instructions

1. 3.5 mm Stereo Earphone Connection:
(A) Insert earphones to the 3.5 mm audio output jack 8. Also, signal cables can be inserted and connected to other audio devices.

(B) Caution: Ascertain to use stereo earphones or headphones. Insert mono earphones might cause damage to the earphone.
(C) Permanent noise-induced hearing damage or loss may occur on  prolonged exposure to loud sounds while wearing earphones or headphones.
(D) Minimize the volume level before the earphone is inserted.

2. Power & Earphone Volume Control:
(A) Power On: Turn the Volume Control 8 clockwise to power on and the LCD will be lighted on and displays the current channel.
(B) Power Off: Turn the Volume Control 8 counterclokwise to the end to power off. OFF … indicator will display temporarily when
the device is turned off. (C) Volume Control: Turn the Volume Control 8 clockwise to increase the volume level, and counterclokwise to decrease the level.
(D) Caution: The device will not power on with insufficient battery power. Replace with a fully charged rechargeable battery and insert with the correct polarity.

Ill. LCD Screen Display

1. LCD Screen Display:
(13) Mode
(14) Parameters
(15) Audio Indicator: Up – left channel. Down – right channel.
(16) Antenna Signal Indicator: Without an antenna icon, the meters indicate the signal strength of the environmental interference.
(17) Battery Meter

(A) In ENG MODE, select YES to enter ENG mode settings. Press the  button or T button 0 to select the program. Up to 16 programs can be saved.
(B) This function can I.e. activated after lire parameters are transmitted from Ml-58T to Ml-o80R by ACT synchronization.
(C) This function ‘” deranged for found engine to monitor each choanal.

8. Allery Indicator
Replace and install fresh/new batteries when the battery indicator shows zero (10%) remaining. The unit automatically shuts down and turns off during vary low voltage.

V. Cautions

1. Avoid using the same frequency bands when MIPRO IEM and wireless microphone systems are utilized at the same installation.

2. The battery hours are related to the output power of the earphone. When the output of the earphone is larger, the current consumption will be larger and the battery hours will be shorter. Choosing earphones with high sensitivity and good isolation will help increase the operating hours. An
   earphone with more than 100 dB is recommended.

3. The Ml-580R receiver uses an ICR18500 lithium battery with 3.7 V nominal voltage and 4.2 V full-charging voltage. The receiver will automatically shut down when the voltage is lower than 3 V. Bororo each use, make sure the lithium battery is fully-charged or use low fresh AA galleries.

4. Use of any disposable, non-rechargeable lithium battery is strictly prohibited. MIPRO is not liable for any damage caused by incorrect batteries and the warranty will be automatically voided.

5. Remove the AA batteries to avoid any damage from leaking whom they will not be used for extended periods.

6. Rechargeable lithium batteries don’t leak and are eco-friendly and money-saving.

Federal Communication Commotion Interference Statement
Thai equipment earn elated 8mJ found to the limits for a Class B digital dovecot. pursuant to Part 15 of the FCC Rule. Theo limits ore deigned to provide  protection against harmful intortoronco in a.

This equipment genera lea, uses and  red1c1te radio frequency energy with toil instructions, may cause harmful intortoronco to radio communications. However, thoron is no guorontoo thot intortoronco will not occur in n particular in . If this equipment does cause harmful inter1erence to radio or television reception, which can be determined by turning the off And on, theft u1u,r is enr.oumg11d to try to r.orrftr.t the interference by one of the following :

• Reorient or relocate though receiving onto no
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver i1 connected
• Consult the dealer or en experienced radio technician for help.

FCC Caution: To aura continued compliance, any cheque or modifications not expressly approved by the party responsible tor compliance could void the user’s authority to  equipment.  use only  interface cables when connecting to computer or peripheral dovecots).

This equipment genera lea, uses and  red1c1te radio frequency energy with toil instructions, may cause harmful intortoronco to radio communications. However, thoron is no guorontoo thot intortoronco will not occur in n particular in . If this equipment does cause harmful inter1erence to radio or television reception, which can be determined by turning the off And on, theft u1u,r is enr.oumg11d to try to r.orrftr.t the interference by one of the following :

This dovecot complies with Pert 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This! device may not cause harmful interference, and
(2) This device must accept any interference received, including interrere11ce hell rend use undetailed operation.

www.mipro.com.tw
mipro@mipro.com.tw

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>