BLACK DECKER HGS100T Compact Garment Steamer User Manual

: June 9, 2024
: Black Decker

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS
TROUBLESHOOTING
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HGS100T Compact Garment Steamer
User Manual

IMPORTANT SAFETY INSTRUCTIONS

When using your steamer, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING.
To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.
Use steamer only for intended use.
To reduce the risk of electric shock, do not immerse the steamer in water or other liquids.
Never pull on the cord to disconnect from the electrical outlet; instead grasp plug and pull to disconnect.
Do not allow cord to touch hot surfaces. Let steamer cool completely before putting away.
Always unplug steamer from the electric outlet before filling with water, emptying, or cleaning, and when not in use.
Do not operate the steamer with a damaged cord, or if the appliance has been dropped or damaged, or if it is leaking. To reduce the risk of electric shock, do not disassemble or attempt to repair the steamer; take it to a qualified service person for examination and repair, or call the appropriate toll-free number in this manual.
Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the steamer is used.
Close supervision is necessary for any appliance being used by or near children. Do not leave the steamer unattended while connected.
Burns can occur from touching hot metal parts, hot water, or steam. Use care when you turn a steam appliance upside down – there may be hot water in the reservoir. Avoid rapid movement of steamer to minimize hot water spillage.
To reduce the likelihood of circuit overload, do not operate another high wattage appliance on the same circuit.
If an extension cord is absolutely necessary, a minimum 10-ampere rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
Do not use outdoors.
Do not use anything other than water in the steamer while in use or during cleaning.
Never steam clothing while on a body.
Never aim the steam directly towards people, animals or plants. The steam is very hot and can results in burns. Burns can occur from touching hot parts (including the steamer head and frames), hot water, or steam.
Never hold the steam head down while at rest or tilt it in a backward position as this may result in hot water discharge and possibly injury.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The steamer must be used and rested on a stable surface.

SAVE THESE INSTRUCTIONS.
This product is for household use only.
POLARIZED PLUG
To reduce the risk of electric shock, this appliance has a polarized plug (one blades wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electrical shock, do not attempt to remove the outer cover. There are no user-serviceable parts inside. Repair should be done only by authorized service personnel.
Note: If the power supply cord is damaged, in order to avoid a hazard, it should be replaced by qualified personnel.
GETTING TO KNOW YOUR STEAMER

1. Ironing plate	5. Tank lock
2. Steam trigger	6. Removable water tank
3. Continuous steam switch	7. Indicator light
4. Handle	8. Steam reset button

HOW TO USE
This product is for household use only.
GETTING STARTED

Remove all labels, tags and stickers attached to the body, or cord of the steamer and the plastic band around the power plug.
Remove and save literature.
Read all the instructions before using your steamer.

IMPORTANT NOTES

Using distilled, purified, or filtered water is highly recommended to maintain optimal performance. Tap water contains minerals that build up over time.
Any water droplets visible inside the tank are from individual quality control tests done to ensure every steamer meets our high standards for product performance.
Do not use perfumes, oils, or other additives.
Always review the garment manufacturer’s care label instructions before steaming, and always test fabrics for colorfastness in inconspicuous areas (such as an inseam). Steamers are not recommended for use on leather, suede, vinyl, plastic, or other steam sensitive fabrics.
The steamer becomes hot during use.
It is normal to feel or hear the water pump in the handle.
The water pump may become louder when the water level in the tank is low. Check and refill tank, as needed.

FILLING THE WATER TANK

Place the steamer on its base on a stable surface.
Hold the handle to stabilize while pressing the tank lock upward and pulling away the removable water tank with the other hand. (A)
Gently pull out the rubber water tank cover at the top of the tank. (B)
Tip: Using distilled, purified, or filtered water is highly recommended and will reduce mineral buildup. Do not use oils, perfumes, or scented additives.
Using a clean measuring cup, pour water into opening until water reaches the “MAX” level mark on the top of the tank. (C) Do not overfill. Close the rubber cover securely.
Dry off any excess water from the tank. While pressing the tank lock upward, push water tank back into the steamer base until it clicks into place.
To refill at any time during use, unplug from outlet, and follow the above procedure.
Tip: After refilling, allow to reheat for 60 seconds until steam forms.

USING THE HANDHELD STEAMER

Read the manufacturer’s fabric label to make sure the fabrics are suitable for steaming.
• If you see “do not iron” or this icon , do not press the ironing plate against the garment.
• If you see “do not steam” or this icon , do not steam the garment.
Place the garment on a hanger.
• Hang against a heat safe surface and use the ironing plate to get crisp results. The ironing plate can also be used in the horizontal position, with a traditional ironing board.
• The steamer may be used by hanging the garment in an area that will not be impacted by the heat and steam, such as on a shower rod.
Plug the steamer into an outlet. The indicator light will slowly blink, indicating that the steamer is heating.
The Ironing Plate will be fully preheated in 1–3 minutes.
Note: The fixed temperature on the ironing plate is a mid-range heat level , which is suitable for most fabrics. If the garment label says not to iron , or iron at low temperatures , do not press the ironing plate against the garment.
To generate steam, press down on the steam trigger with your index finger. (D) As long as the trigger is held down, steam will emit from the steamer. When the trigger is released, the steam will stop.
• To generate a constant flow of steam without holding the trigger, press the steam trigger and then slide the continuous steam switch down. (E) This will activate the continuous steam feature. To turn the steam off, press the trigger, push the continuous steam switch up and then release trigger.
Note: It is normal to feel or hear the water pump in the handle.
To iron using the Ironing Plate on a heat safe surface placed vertically, start steaming and then lightly press the metal ironing plate against the garment. (F) While holding the fabric gently taut, drag the ironing plate up and down the fabric, being careful to keep hands away from the steam and never leaving the plate in one section for too long; like how a typical iron is used.
Stand steamer on its base and allow it to completely cool off before storing. (G) To avoid mineral buildup, empty the tank after each use.

STEAM CLEANING IN THE HOME
Using steam to clean household items that can tolerate hot, damp steam without damage is non-toxic, and inexpensive. This cleaning method is beneficial to those sensitive to chemical cleaners or trying to reduce chemicals in the home. Steam upholstery, draperies, linens and home textiles to clean and refresh.
CLEANING AND CARE
This product contains no user serviceable parts. Refer to qualified service personnel.
CLEANING STEAMER EXTERIOR

Make sure steamer is unplugged and completely cool.
Wipe the ironing plate and outer surface with soft, damp cloth. Water and small amounts of gentle household soaps, such as dishwashing liquid, can be used on the exterior. Never use heavy-duty cleaner, or abrasive scouring pads that may scratch or discolor the steamer.
After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This will help remove any reside left in the steam holes.
Unplug, empty tank, and allow time to cool before storing.

STORING THE STEAMER

Check that the steamer is unplugged and completely cool.
Wrap the cord loosely around the base of the steamer.
Always store steamer upright on its base to prevent water leakage.
Tip: Emptying the tank after each use is recommended because standing water can leave a residue over time.

STEAMING TIPS AND TRICKS

This steamer is designed to use distilled, purified, or filtered water. Tap water contains minerals that build up. Using water with perfumes or scented additives is also not recommended.
Always test garments by steaming a small hidden area to make sure the garment takes well to steam.
Always read garment care label instructions. Fabrics suitable for mid to high heat can be pressed with the ironing plate.
mall amounts of dripping might occur during use. If excessive, either the steamer needs time to get back up to full temperature or there could be a build-up of condensation on the ironing plate. Just allow the steamer a minute to reheat, or gently wipe the ironing plate against the ironing pad fabric to remove condensation.
To prevent iron marks on fabric, turn garment inside out before using the ironing plate. Sensitive items (such as items with embellishments) should be steamed inside out as well to avoid damage.
Putting on a garment immediately after ironing or steaming can actually create wrinkles. Always allow clothing to cool for about 5 minutes after ironing or steaming to set the press.

TROUBLESHOOTING

Problem	Possible Cause	Solution
The steamer is plugged in but not heating.	There’s a power supply issue.

Check that the plug is properly inserted into the outlet or try plugging the steamer into a different outlet.
Not enough steam or no steam is coming out of the steamer.| The steamer isn’t heated up to full temperature.| Always allow steamer to preheat at least 60 seconds.
There is not enough water in the water tank.| Follow the instructions under the “filling the water tank” section and fill to Max level marker.
The steamer has not been used for several weeks or more and an air pocket is blocking the steam,| Push the “steam reset” button on the bottom of the unit. The steam reset button pushes no through the pump.
Discolored water is coming through the holes and staining the fabric.| Residue has built up in the water tank or on the ironing plate.| Empty the water tank after each use. Only use distilled, filtered, or purified water.
Perfumed or scented additives were used.| Regularly clean steamer and refrain from using perfumed or scented additives.
Starch was used.| Always clean steamer ironing plate after using starch.
Steamer is leaking or spitting.| Steamer is not hot enough.| Allow the steamer to heat for about 45 seconds.
Condensation has built up.| Gently wipe the ironing plate with a soft, damp cloth to remove condensation.
Water tank is running low.| Follow the instructions under the “Filling the Water Tank” section and fill to Max level marker.

If additional assistance is needed, please contact our consumer service team at 1-800-465-6070.
NEED HELP?
For service, repair or any questions regarding your appliance, please call our Customer Service Line at 1-800-465-6070. Please DO NOT return the product to the place of purchase. Also, please DO NOT mail product back to manufacturer, nor bring it to a service center. You may also want to consult the website listed on the cover of this pamphlet.
Warranty Information
(Applies only in the United States and Canada)
What does it cover?

Any defect in material or workmanship provided; however, Spectrum Brands’ liability will not exceed the purchase price of product.

For how long?

Two years from the date of original purchase with proof of such purchase.

What will we do to help you?

Provide you with a reasonably similar replacement product that is either
new or factory refurbished.

How do you get service?

Save your receipt as proof of date of sale.
Visit the online service website at www.prodprotect.com/blackanddecker, or call toll-free 1-800-465-6070, for general warranty service.
If you need parts or accessories, please call 1-800-738-0245.

What does your warranty not cover?

Damage from commercial use
Damage from misuse, abuse or neglect
Products that have been modified in any way
Products used or serviced outside the country of purchase
Glass parts and other accessory items that are packed with the unit
Shipping and handling costs associated with the replacement of the unit
Consequential or incidental damages (Please note, however, that some states do not allow the exclusion or limitation of consequential or incidental damages, so this limitation may not apply to you.)

How does state law relate to this warranty?

This warranty gives you specific legal rights. You may also have other rights that vary from state to state or province to province.

www.BlackAndDeckerAppliances.com
1000W 120V~ 60Hz.
Argentina
Attention al consummator
0800 444 7296
Horacio the attention:
Lunes a Viernes de 9 a 13 has
y de 14.30 a 17 has.
email: servicios@spectrumbrands.com
Humboldt 2495 peso 3
C.A.B.A. – Argentina
Imported Distribution pore:
RAYOVAC ARGENTINA S.R.L. Humboldt
2495 Paso# 3 C1425FUG) C.A.B.A.
Argentina C.U.I.T NO. 30-70706168-1
BLACK+DECKER and the BLACK+DECKER logos and product names are trademarks of
The Black & Decker Corporation, used under license. All rights reserved.
All other marks are Trademarks of Spectrum Brands, Inc.
Made in China.
© 2018 The Black & Decker Corporation and Spectrum Brands, Inc., Middleton, WI 53562