Goon Technology TX60RF Silent Disco Headphones User Manual

Goon Technology TX60RF Silent Disco Headphones

PARTS

1. Channel switching button
2. Channel LED
3. Microphone indicator
4. Microphone power switch button
5. Microphone volume control knob
6. Microphone input jack
7. OAudio input jack
8. Charging status indicator
9. Power switch
10. Charging power input socket
11. Battery cover
12. Portable buckle

Technical specifications

1. System: UHF/RF
2. Modulation: frequency modulation
3. Mode: stereo
4. Transmitter channel: three channels
5. Operating distance:> 300m
6. Stereo channel separation: 50dB
7. Distortion: < 1%
8. Frequency response: 30hz-15khz
9. Charging adapter: DC12V 1.3A
10.  Battery charging time: about 4 hours
11. Battery continuous service time: more than 10 hours

How to use the transmitter

Transmission: turn on the power switch , connect the audio input at the audio input jack D, match the transmitter
with the headphone channel, and then listen to the transmitted audio signal.

Channel switching: tap the channel switching buttonto switch the channel display LED . Charging: turn off the power switch , connect the charging adapter at the charging power input jack, the charging indicator ®is on, the charging state indicator is red and the full charge indicator is green

Charging while working: connect the charging adapter at the charging power input socket , turn on the power switch . and the charging indicator is on and always showed red. At this time, it means that the transmitter is charging while working. Only after turning off the power switch , if the battery is fully charged, the charging indicator is showed green, otherwise it is showed red, indicating that it is charging.

Microphone: in microphone input jack. press microphone switch button. indicator is on, and the transmitter will give priority to transmitting microphone audio signal. Press microphone switch button again, indicator Ois off, turn off the microphone, and the transmitter will switch back to the original state.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>