HyperX HX433C16PB3/8 8GB 1G x 64-Bit DDR4-3333 CL16 288-Pin DIMM Memory Module User Guide
- June 9, 2024
- HYPERX
Table of Contents
HX433C16PB3/8 8GB 1G x 64-Bit
DDR4-3333 CL16 288-Pin DIMM Memory Module
User Guide
Memory Module Specifications
HX433C16PB3/8
8GB 1G x 64-Bit
DDR4-3333 CL16 288-Pin DIMM
DESCRIPTION
HyperX HX433C16PB3/8 is a 1G x 64-bit (8GB) DDR4-3333 CL16 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 1G x 8-bit FBGA components per module. Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Each module has been tested to run at DDR4-3333 at a low latency timing of 16-18-18 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:
XMP TIMING PARAMETERS
- JEDEC: DDR4-2400 CL17-17-17 @1.2V
- XMP Profile #1: DDR4-3333 CL16-18-18 @1.35V
- XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V
SPECIFICATIONS
| CL(IDD) | 17 cycles |
|---|---|
| Row Cycle Time (tRCmin) | 45.75ns(min.) |
Refresh to Active/Refresh
Command Time (tRFCmin)| 350ns(min.)
Row Active Time (tRASmin)| 32ns(min.)
Maximum Operating Power| TBD W*
UL Rating| 94 V – 0
Operating Temperature| 0°Cto +85°C
Storage Temperature| -55°C to +100°C
*Power will vary depending on the SDRAM used.
FEATURES
- Power Supply: VDD = 1.2V Typical
- VDDQ = 1.2V Typical
- VPP = 2.5V Typical
- VDDSPD = 2.2V to 3.6V
- On-Die termination (ODT)
- 16 internal banks; 4 groups of 4 banks each
- Bi-Directional Differential Data Strobe
- 8 bit pre-fetch
- Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
- Height 1.661” (42.20mm)
MODULE WITH HEAT SPREADER
MODULE DIMENSIONS
All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
The product images shown are for illustration purposes
only and may not be an exact representation of the product.
Kingston reserves the right to change any information at anytime without
notice.
FOR MORE INFORMATION, GO TO
WWW.HYPERXGAMING.COM
All Kingston products are tested to meet our published specifications. Some
motherboards or system configurations may not operate at the published HyperX
memory speeds and timing settings. Kingston does not recommend that any user
attempt to run their computers faster than the published speed. Overclocking
or modifying your system timing may result in damage to computer components.
HyperX is a division of Kingston.
©2018 Kingston Technology Corporation, 17600 Newhope
Street, Fountain Valley, CA 92708 USA. All rights reserved.
All trademarks and registered trademarks are the property of their respective
owners.
Document No. 4808706A
hyperxgaming.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>