ACT AC8370 TV and Monitor Floor Stand Installation Guide
- June 9, 2024
- ACT
Table of Contents
- ACT AC8370 TV and Monitor Floor Stand
- Component Checklist
- Package
- Assembling the Base
- Attaching the Column to the Base
- Attaching the Universal Plate to the Column
- Installing the Adapter Brackets
- Angle Adjustment
- Installing the Camera Shelf
- lnstalling the Shelf
- Cable Management
- Adjustment
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ACT AC8370 TV and Monitor Floor Stand
You can find safety information at www.act-
connectivity.com/safety
For service, manuals, firmware or updates visit www.act-
connectivity.com
Made in China
5 Year Warranty
- It is recommended to adjust the columns to the desired height before installing the display.
- If you want to adjust the columns height after finishing the display installation. Please remove the shelf, then adjust the columns to the desired height.
Maintenance
- Check that the bracket is secure and safe to use at regular intervals (at least every three months). Flatscreen Shelf
- Please contact your reseller if you have any questions.
Read the entire instruction manual before you start installation and assembly. If you have anyquestions regarding any of the instructions or warnings, please contact your local reseller for assistence.
CAUTION
- Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Required for Installation
Component Checklist
IMPORTANT : Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of purchase for a replacement.
Package
Assembling the Base
Attach the right base to the middle base and secure with screws(P). Repeat
this step for the left base.
NOTE : Lock the brakes on the casters to avoid any sudden movements
during installation.
Each caster can be adjusted independently for fine tuning adjustments.
Slightly turn the nut to lower or raise the base.
Attaching the Column to the Base
Pull the pin outwards and pull the inner column upwards at the same time,
until the inner column is pulled to the desired height then release the pin to
secure.
Attaching the Universal Plate to the Column
Attach the universal plate to the column using the appropriate screws.
Installing the Adapter Brackets
For Flat Back Screens
For Bump-out or Recessed Back Screens
Note : Ch00se the appropriate screws, washers and spacers (it necessary) according to the type of Screen,
Position the adapter brackets as close as possible to the center ot the
display.
Screw the adapter brackets onto the display.
Tighten all screws but do not over tighten.
Hanging the Display onto the Universal Plate
Hook the display onto the universal plate. Tighten four screws to secure them.
Important : Make sure the display is mounted correctly and the screws are
tightened safely before releasing the display.
For Landscape or Portrait View
Angle Adjustment
Installing the Camera Shelf
Attach the camera shelf to the connecting plate With the appropriate screws.
Tighten all screws using a proper Phillips screwdriver.
lnstalling the Shelf
lnstalling the Cable Covers
Cable Management
Adjustment
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>