SHOPMAX 93606C2-06A4 Tool Chests and Rolling Tool Cabinet and Combos User Manual

SHOPMAX 93606C2-06A4 Tool Chests and Rolling Tool Cabinet and Combos

SERIAL NUMBER
Both model number and serial number may be found on the carton.

PURCHASE DATE
You should record both of them in a safe place for future use

WARNING
Carefully read and understand this entire operator’s manual before installing and using this product. Pay attention to all the cautions and warnings

SPECIFICATIONS

SYMBOLS
The labels on your product may show symbols. These represent important information about the product or instructions on is use.

SAFETY INSTRUCTIONS

SIGNAL SAFETY WORDS DEFINITION
The definitions below give the level of severity for each signal word.

DANGER
This symbol is used to indicate a hazardous situation which, if not avoided. will result in serious injury or death.

WARNING
Read and follow all instructions before attempting to operate this product. Failure to comply with these instructions could result in serious injury or death.

CAUTION
This symbol indicates a hazard, which, if not avoided, may result in minor injury, moderate injury, or property damage

NOTE
This information makes the product easier to use

ASSEMBLY SAFETY

WARNING

• Assemble only according to these instructions. lmproper assembly can create hazards.
• Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.
• Keep assembly area clean and well lit.
• Keep bystanders out of the area during assembly.
• DO NOT assemble when tired or when under influence of alcohol, drugs or medication.
• Weight capacity and other product capacities apply to properly and completely assembled product only.
• Assemble on a flat, level, hard and smooth surface capable of safely supporting a fully loaded Chest/Cabinet.

OPERATION SAFETY

DANGER

• DO NOT sit, stand or climb on this unit.
• This product Is not a toy nor a toy chest. Do notallow children to play with or near this item.
• Be aware of dynamic loading! Sudden load movement may briefly create excess load causing product failure. Do not exceed capacity of the bench or shelf supporting Top Chest.
• DO NOT open more than one drawer at once. This chest/ cabinet/Workbench may become unstable and tip over causing personal injury and/or product damage.
• Be careful! when closing the drawers, the cover or doors. Remove hands before the cover/drawer/door close completely to prevent personal injury.
• DO NOT place any objects on top of a closed lid.

WARNING

• Make sure the lid lock or drawer lock is in the unlocked position before closing the lid or drawer. Failure to do so could result in a defective lock system and/or personal injury.
• Before locking, make sure the drawers are completely closed in order for lock system to work properly.
• Empty, close, and lock drawers before moving.
• DO NOT pull this product, push it when moving. Pushing the unit will prevent serious ankle and foot injuries.
• DO NOT move the item after stacking the top chest on the bottom cabinet it could cause the chest to topple.
• Use only on flat, level, hard and smooth surface capable of safely supporting a fully loaded Chest/Cabinet. Do not roll Cabinet over concrete seams or other rough/uneven surfaces.
• DO NOT move or lift while loaded. Do not lift using handle(s).
• To prevent tipping, move using supplied handle on Bottom Cabinet only.
• Apply caster brakes unless moving the item.
• Secure this product properly before moving it with a forklift.
• DO NOT tow the product by mounting on truck bed or any other moving object. This may cause personal injure or product damage. Mounting this product otanyvehicle in any manner will void warranty.
• Use as intended only. Do not use for food preparation.
• DO NOT alter this product in any manner. For example, do not weld external lock bars or attach electrical equipment.
• Inspect before every use; do not use if parts are loose or damaged.
• Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, Call us at 847-327-0566 or 844-YARDMAX, email us at info@shopmax.com for a replacement.

ELECTRIC SAFETY

DANGER
Follow all manufacturer’s warnings and operating instructions about electric safety

• DO NOT use in an explosive atmosphere. Grounding required.
• ChesUCabinet plugs must match the outlet.
• Never modify the plug in anyway.
• DO NOT use any adapter plugs with earth (grounded) chest power strips.
• Unmodified plugs and matching outlets will reduce the risk of electric shock.
• Electrical shock hazard. Do not plug the cord into the outlet if your hands are wet. Do not use this product near a bathtub, a shower, or a swimming pool. Make sure all cords are unplugged before any servicing or cleaning. Follow manual for recommended usage.
• Avoid body contact with earthed or grounded surfaces. There is an increased risk of electric shock if your body is earthed or grounded.
• DO NOT insert extension cord through the hole without grommet in place.
• Check the insulation and plugs of extension cord before using. DO NOT use cord if it is worn or damaged.
• Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong.
• Extension cord must be connected to a 125 Volt GFCI protected outlet with proper ground. If GFO outlet is not available, use an extension cord with GFO protection built in.
• DO NOT overload extension cord.
• Remove extension cord from the hole before moving or transporting storage chesUcabineUwork station.
• Only use an extension cord that is rated for outdoor use.
• DO NOT connect an extension cord to outlet that also supplies critical safety equipment with power.

CAUTION
RISK OF ELECTRICAL SHOCK: Make sure all cords are unplugged before any servicing or cleaning.

FCC STATEMENTS

WARNING
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

NOTE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user Is encouraged to try to correct the interference by one or more ofthe following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radionv technician for help.

INSTALLATION AND OPERATION

UNPACKING THE CONTAINER
Use sccissors or a knife to cut all the straps. Lift off the carton and dispose of property

Your SHOPMAX product comes partially assembled and contains the following:

Hardware Kit, Included

Recommended Tools
To assemble your SHOPMAX Chest/Cabinet, you will need a 14 mm wrench, and a phillips screwdriver.

NOTE
Tools Needed for Assembly, not Supplied.

ASSEMBLY

CAUTION
Two people are recommended for assembly.

BOTTOM CABINET

Cabinet Side Handle Installation
Position the cabinet side handle over the holes on the cabinet. Attach with the four screws and tighten with a Philips screwdriver (not supplied).

Casters Installation

1. Be sure the drawers are locked and lay the cabinet on its backside. Using packing material to protect the unit.
2. Attach the two locking swivel casters to the cabinet, on the same side as the cabinet side handle, tighten with bolts, spring washers and flat washers.
3. Repeat to install the two static casters on the opposite side of the cabinet

TOP CHEST

Foot Pin Installation
Press in the four foot pins into the bottom of the top chest.

Final Assembly
Using an assistant, place empty top chest on the top of the cabinet.

WARNING
Make sure the top chest is seated inside the bottom cabinet’s edges

OPERATION

WARNING
For safety, evenly distribute the weight of tools between all drawers. The even distribution will prevent the unit from becoming top-heavy and accidentally tipping when a drawer is opened

GENERAL OPERATION

1. Empty all drawers.
2. Close all drawers and lock them.
3. Unlock swivel casters.
4. To prevent tipping, move using the handle on the bottom cabinet only. Roll cabinet to a flat, level, hard and smoothsurface capable of safely supporting a fully loaded cabinet. Do not roll the cabinet over concrete seams or other rough! uneven surfaces.
5. Lock swivel casters.
6. Unlock drawers and fill them evenly, from bottom to top. Do not exceed weight capacities

REMOVE THE DRAWER

1. Empty the drawer.
2. Fully extend the drawer.
3. Push the lever on the right slide down, lift the lever on the left side up. Pull out drawer to remove

INSTALL THE DRAWER

1. Pull slides and slide carrier out to a fully extended position (See Figure liD).
2. Hold the slide on the cabinet while aligning it with the slide on drawer.
3. Slightly insert one side and repeat for the other side. Slowly push the drawer to its fully closed position to engage the slide.
4. Open drawer and reclose to ensure proper operation.

USING THE CASTER BRAKES
To lock the swivel casters, step down on the lever marked ON. Be sure to lock all four swivel casters to prevent the chest/cabinet from rolling. To unlock casters, push down on the levers marked OFF.

POWER STRIP
Passing cords through the rubber grommet. Be sure to follow all electrical safety precautions.

DANGER

• DO Nar use in explosive atmosphere. Grounding required.
• Electrical shock hazard. Do not plug cord into the outlet if your hands are wet.
• Do not use this product near a bathtub, a shower, or a swimming pool

MAINTENANCE

WARNING
Procedures not specifically explained in this manual must be performed only by a qualified technician.

WARNING
To prevent serious injury from tool failure, do not use damaged equipment. If any part becomes damaged, have the problem corrected before further use.

PERIODICAL INSPECTION

• Loose hardware.
• Misalignment or binding of moving parts.
• Brake operation.
• Caster swivel function and movement.
• Cracked or broken parts.
• Any other condition that may affect its safe operation.

CLEAN

• Use mild detergent and water to clean drawer fronts, drawer trim and the other surfaces.
• Grease and oil can be removed with standard, non-abrasive, nonflammable cleaning products.

LUBRICATION

Casters
Lubricate the casters once a year with high quality ball bearing grease. This may be required more often if operating the tool box in colder climates.

Slides
Lubricate the slides semi-annually with high quality, petroleum-based lubricant. This may be required more often if operating the tool box in colder climates.

EXPLODED VIEWS & PARTS LIST

PARTS DIAGRAM

WARRANTY

WARRANTY INFO
The warranty set forth below is given by YARDMAX with respect to new merchandise purchased and used in the United States and/or its territories and possessions. YARDMAX warrants its product, subject to limitations and exclusions below, against defects in material and workmanship for a period of three (3) years commencing on the date of original purchase, and will, at its discretion, repair or replace, free of charge to the customer, any part found to be defective in material or workmanship when the product is solely used for residential purposes during the three (3) year period

LIMITATIONS AND EXCLUSIONS

YARDMAX’s warranty does not cover normal wear and tear, neglect, accident, improper assembly, improper maintenance, modification, alteration, improper repair, use of parts not approved by YARDMAX or product damage due to misuse by the customer. Replacement of products or parts due to normal wear and tear is the responsibility of the customer. Proof of original purchase is required. The warranty  is non-transferrable. This limited warranty shall only apply if the product has been assembled, operated, and maintained in accordance with Owner’s Manual supplied with the product. No Implied Warranty, including any implied warranty of merchantability or fitness for a particular purpose, applies after the expiration of the applicable period of express written warranty provided above. No other express warranty, whether written or oral, except mentioned herein, given by any person or entity, including a dealer or retailer, with respect to any product, shall bind YARDMAX. The provisions as set forth herein in this warranty provide the sole and exclusive remedy arising from the sale. YARDMAX shall not be liable for incidental or consequential damages to the extent allowable by law. The customer may have other rights not disclosed herein; and they may vary from state to state.

Have questions obout your SHOPAfAX equipment?
Call us at B47-327-IJ566 or 844-YARD~ email us at info@Shopmax.com. www.shopmax.com

Your Tools. Your Shop.™
847-327-0566 | info@shopmax.com

References

• Shopmax tool chests, tool cabinets, and combos – Affordable and Durable
• Shopmax tool chests, tool cabinets, and combos – Affordable and Durable

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>