SIEMENS ED-32 System 3 Control Panel Door Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
SIEMENS ED-32 System 3 Control Panel Door
INTRODUCTION
The ED-32, ED-33(R) and ED-35(R) Doors from Siemens Industry, Inc., mount on
EB-32, EB-33 and EB-35 back boxes, respectively. Door models ending in R are
red, those without an R are black. The door is mounted with a sag resistant,
steel piano hinge and is fitted with a key locking arrangement. Left hand or
right hand mounting can be made on all enclosures as desired. Each door
contains full-width horizontal viewing slots, to permit visual identification
of each row of modules and control panel for the various functions served by
the system. The inside of the door is fitted with brackets to accommodate
blank face plates to cover those positions in the back box not occupied by the
control panel or modules. Enclosures are shipped unassembled (back box and
door cover) to facilitate installation. All that is required is to bolt the
complete system assembly in position in the back box and mount the hinged door
cover assembly.
INSTALLATION
Using the hardware provided, attach two of the screws and lock washers to the side of the back box opposite from the side where you want the door to open. Hang the door on the screws, then tighten the screws securely. Install screws and lock washers in the remaining holes on the side of the enclosure where the door is being mounted and tighten them securely.
Install the guide pin on the inside top of the door as shown in Figure 1.
Install the grounding strap by placing the lug on one end of the strap over
the #6×32 stud on the door and the lug on the other end of the strap on the
6×32 stud on the inside of the enclosure. Secure the lugs in place with the
two #6 hex nuts provided. Refer to Figure 1.
Siemens Building Technologies, Ltd.
Fire Safety & Security Products 2 Kenview Boulevard Brampton, Ontario L6T 5E4
Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>