SIEMENS DF-SX Dead Front Panel for the EN-SX Enclosure Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
SIEMENS DF-SX Dead Front Panel for the EN-SX Enclosure Instruction Manual
The Model DF-SX from Siemens Industry, Inc., is an optional dead-front panel that is used on the EN-SX enclosure to cover and protect the electronic components.
MOUNTING
- Insert the #6-32 x 5/16 screw provided in the tap hole of the EN-SX enclosure, as shown in Figure 1. Tighten the screw in place leaving a 1/4 -inch gap between the head of the screw and the EN-SX enclosure.
- Insert the tabs of the DF-SX through the slots in the top of the EN-SX enclosure (Refer to Figure 1). Let the dead front cut-out rest on the screw.
- Tighten the screw in place. Make any adjustments necessary to ensure the door of the enclosure closes properly.
Siemens Industry, Inc. Building Technologies Division Florham Park, NJ
P/N 315-095991-5
Siemens Building Technologies, Ltd. Fire Safety & Security Products 2 Kenview Boulevard Brampton, Ontario L6T 5E4 Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>