SIEMENS HTSW-1 Door System Tamper Switch Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
System Tamper Switch
Installation Instructions
Model HTSW-1
INTRODUCTION
The Model HTSW-1 Tamper Switch is a 3-position switch that monitors the opening of the CAB1, CAB2 or CAB3 enclosure and reports a security alarm. Closing the door automatically returns the switch to its normal operating position. The switch can be pulled out to indicate a closed position for maintenance purposes.
INSTALLATION
Disconnect BATTERY and AC prior to working on equipment.
If your configuration is UL 1076, it requires the HTSW-1 Tamper Switch.
The HTSW-1 mounts into the rectangular slot located in the frame of the
backbox of a CAB1, CAB2 or CAB3 enclosure. Refer to Figure 2 for the location
of the knockout slots for the tamper switch.
If the outside door of the enclosure opens on the left, install the tamper switch on the right side of the enclosure. If the outside door of the enclosure opens on the right, install the tamper switch on the left side of the enclosure.
-
Snap tamper switch through opening in frame of backbox. (Refer to Figure 3.)
-
Connect quick disconnect wires to tamper switch. (Refer to Figure 4.)
• Connect one wire to position marked “COM”
• Connect one wire to position marked “N.O.” -
Plug cable on HTSW-1 into P5 on PSC-12 (Refer to Figure 5).
**COMPATIBILITY
**
The HTSW-1 can be used in CAB1, CAB2 or CAB3 enclosures.
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario
L6T 5E4 Canada
P/N 315-033350-4
firealarmresources.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>