SIEMENS RR-35 Remote Reset Module and Remote Reset Station Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
Installation Instructions
Models RR-35 and RRS
Remote Reset Module and Remote Reset Station
(for use with System 3)
OPERATION
The Model RR-35 Remote Reset module from Siemens Industry, Inc. allows a
System 3 alarm condition to be reset to Standby from a remote location. (An
alarm condition can also be reset by using the CP-35 Control Panel RESET
switch.)
System 3 uses a BC-35 battery backup configuration.
Use the interconnecting cable, P/N 600-191771, that is supplied. (See Figure
2.)
The Model RRS Remote Reset station includes a labeled single gang plate and a
normally closed, key operated, spring return reset switch.
INSTALLATION AND WIRING
Follow the Connection Diagram (Figure 1) and Figure 2 to install and wire the
RR-35/RRS into a System 3 configuration.
Refer to System 3 Wiring Information Field Assembly of Modules, P/N
315-085178.
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
P/N 315-091469-7
Siemens Canada Limited
Building Technologies Division
2 Kenview Boulevard
Brampton, Ontario L6T 5E4 Canada