SIEMENS TSW-2 Tamper Switch Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
SIEMENS TSW-2 Tamper Switch
Installation Instructions
Model TSW-2
Tamper Switch
INTRODUCTION
The Model TSW-2 Tamper Switch from Siemens Industry, Inc. (Figure 1) is a 3
-posi-tion switch that monitors the opening of the MXL/MXL-IQ enclosure and
reports a security alarm. Closing the door automatically returns the switch to
its normal operating position. The switch can be pulled out to indicate a
closed position for maintenance purposes.
INSTALLATION
Refer to Figure 2.
If your configuration is UL 1076, it requires the TSW-2 Tamper Switch.
The TSW-2 mounts into the rectangular slot located in the upper right side of
the MHD-2 panel in an MXL system or into the rectangular slot located in the
lower right side of the MKB-4 panel in an MXL-IQ system.
- Place the cable/connector and the switch terminals through the opening and press firmly into place.
- Plug the cable on the TSW-2 into P9 on the MMB (MXL system) or SMB-1/-2 (MXL-IQ system) after installing the MMB or SMB-1/-2.
For additional information on the MXL/MXLV System, refer to the MXL/MXLV Manual, P/N 315-092036.
Siemens Industry, Inc.
Building Technologies Division
Florham Park, NJ
P/N 315-092433-6
Siemens Building Technologies, Ltd.
Fire Safety & Security Products
2 Kenview Boulevard
Brampton, Ontario
L6T 5E4 Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>