GUSOYO DX8 Smart Projector User Guide
- June 9, 2024
- GUSOYO
Table of Contents
DX8 Smart Projector
User Guide
SMART PROJECTOR
( Celcome Guide )
DX8 Smart Projector
Before you start, please read this product manual carefully.
FCC Statement
This device complies with part 1 5 of the FCC Rules. Operation i s subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1 5 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver i s connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee i s not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. such
modifications could void the
user’ s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. To
maintain compliance with FCC’s RF exposure guidelines, the distance must be at
least 20 cm between the radiator and your body, and fully supported by the
operating and installation configurations of the transmitter and its
antenna(s).
PACKING LIST
PRODUCT BRIEF
REMOTE CONTROL
BASIC PARAMETERS
Display Technique| LCD| Type of light
Specifications| LED| Product Type| Desktop
---|---|---|---|---|---
Size| 129.7121200mm| Keystone correction| Four point correction| Focus way|
Manual focus
Weight| 1.12KG| Throw Ratio| L2:1| Speaker| 5W*2
INDICATOR STATUS
| Operating State | Red Light | Blue Light |
|---|---|---|
| Standby | ON | OFF |
| Starting up | OFF | ON |
INSTRUCTIONS
Power on
Method 1: Press the power button o n the top of the projector to turn it
on;
Method 2: Point the remoter control at the projector, and press the power
button o f the remote control to turn it on.
OFF
Short press the power button of the projector or the power button o n the
remote control once. When the prompt box for shutdown appears, short press the
power button again o r the power button o n the remoter control,
GENERAL FAULT DESCRIPTION
| The Fault | The solution |
|---|---|
| Unable to display projection | Shut down and reboot |
| Android crash | Shut down and reboot |
| Abnormal projection | Shut down and reboot |
| System prompt the projector is over heated, or automatic shut-down | Please do |
not block the front air outlet and rear air inlet mesh, restart
PRODUCT CONSIDERATION
- When using the projector, please do not watch the lens directly to avoid damage to the eyes.
- Please do not use in hot and humid environment.
- Please do not block the air outlet or air inlet.
- Please make sure there is at least 30cm space around the projector without any obstructions.
Warning:
- Block the projector Vented slits and openings.
- Wipe the device with a scrub, paraffin or solvent.
- Used under the following conditions:
- Extrerely hot, cold or humid environment.
- Ensure indoor temperature i s between 5-40° C .
- Relative humidity is 80% maximum at 540° C , no condensation.
- Areas susceptible to large amounts of dust and dirt.
- Near any equipment that produce strong magnetic field
- Sunlight exposure directly.
- The product is suitable for non-tropical climate.
Note:
Without the consent of the manufacturer, the user should not disassemble,
squeeze or impact the projector, and avoid use in high temperature, high
pressure, flammable and explosive environments. The manufacturer does not take
any responsibility for damage to the projector caused by human reasons!
BLUETOOTH CONNECTION
In the main interface, use the remote control “Λ” key to turn up the menu bar,
select “setting” to enter the interface and then select “Bluetooth”, select
“Search Bluetooth”
in the right column, select the name of the corresponding Bluetooth device and
press “OK” to automatically connect, select “Pair”, Bluetooth device matching
connection success.
PROJECTIO N SIZE DISTANCE TABLE
Projection size (inch, no keystone correction)| *Screen
lengthwidth(m)| Lens screen (m)*
---|---|---
30| 0. 70. 4| 0.94
40| O. 910. 51| L23
50| 1.130. 64| L51
60| 1. 360. 77| 1.80
70| 1. 570. 88| 2.
80| 1.781. 0| 2.
90| 2.O1.12| 3.
100| 2. 20*1. 24| 3.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>