EOTO LIGHT 14P LED Key Light User Manual

: June 9, 2024
: EOTO LIGHT

Table of Contents

PRODUCTPARAMETER
SHOWDETAILS
BLUETOOTHSHUTTER
REMOTECONTROL
INSTALLATIONSTEPS
PACKAGE INCUDING
ACTIVITE WARRENTY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

EOTO LIGHT 14P LED Key Light

PRODUCTPARAMETER

1 4P Product Parameters

Product	14 inch Key Ligh
Diameter	34cm
Product Functions	Remote control/touch/display
Color temperature	3000-6000K
Input voltage	100~240VAC
Color rendering index	100~240VAC RA>90
Power	40W
Number of LED beads	105+105 0.5W
Material	ABS+PC
Lamp bead lif	3 years
Power supply mode	AC
Light color	White light/warm white/natural light

SHOWDETAILS

Touch screen control and LED display

BLUETOOTHSHUTTER

Turn on the Bluetooth switch on the left side (the blue light flash)
Open your smartphone bluetooth setting
Search for “AB Shutter 3” and connect it (the light stops flashing after connected )
Open your camera , and click the button to take photos or video .

REMOTECONTROL

FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

INSTALLATIONSTEPS

Open the latch and adjust the height
Unfold the desk stand, tighten and fix it
Adjust the knob at the bottom of the stand to fix on the desktop.
Loosen the key light scew knob, connect the stand with the lamp and tighten the screws.