FEILEAP 2.4GHz RC Spray Gasboat Instruction Manual

FEILEAP 2.4GHz RC Spray Gasboat

LIGHT INDICATOR

Remote Control Battery Installation

1. Open the battery compartment: Align the screwdriver with the small contact point on the battery cover and gently press down while grading the battery cover to open.
2. Insert 2 x 1SV “AA” batteries into the battery compartment of the remote controller with Correct polarity.
3. Close the battery compartment Tighten the screw by tuming clockwise with a phillips screwdriver.

OPERATE

The Toy Body Battery Installation

1. Open the battery compartment Align the screwdriver with the small contact point on the battery cover and gently press down while
   dragging the battery cover to open.

2. Insert one 3W rechargeable battery batteries into the toy battery compartment of with correct polarity.

3. Close the battery compartment: Tighten the screw by tuning clockwise with a phillips screwdriver.

USB Charging

The light is constantly on while the battery is charging and when the light goes out, the charging is completed.

How To Play

• Put the toy in water and the Light on the top ill lashing, Then turn on the remote control, And the light of the remote control will light up to complete the inking between. (Note: if the red light of the remote control keeps flashing, The linking within unsuccessful Pick up toy from the water again,Turn off the remote control And re-aperate acording to the above method, And wait for the successful linking.)
• On the left button of the remote control is the automatic demonstration of swimming process
• On the right button of the remote control is the spray. (Press once the spray, Press again to turn off the spray)

Caution:

1. This product is a children toy that will swim in the water through the 2.46iHz wireless remote control
2. This product has the function of automatic pairing, After successful pairing, t can only be controlled one-to-one.
3. While pairing Put hte toys and remote controller as chase as possible,
4. The toy has the function of sensing water, The motor will stop running once is taken aut of the water.
5. The toy possesses the waterproof function.
6. The remote controller possesses the waterproof function
7. Remote control distance: About 30 meters in an unimpeded environment.
8. Operate only in claim clear water, Pocls and shallow are recommended
9. After each use, Wipe whit a towel and allow to dry completely.
10. Do not operater near concrete wails which may disturb transmission.
11. Your designed for operation in fresh water, Do not submerge the water for a long time.
12. Maximum 10 players at a time.

WARNING:

• This product must be used under the supervision of adult,
• This product contains small parts and is not suitable for children under 3 years old to avoid swallowing them and causing asphyxia.
• Never let children play alone in the water or near a pond.
• The toy can only be used in water after it is fully installed according to the user’s Manual.

BATTERY NOTICE

1. The remote control requires two 15V AA non-rechargeeble batteries (not provided;
2. The toy body requires one set of 3,7V rechargeable batteries (provided
3. Do not charge the non-rechargeable batteries;
4. Do not mix new and old or different types of batteries;
5. Please note the polarity when installing or replacing the battery
6. The exhausted batteries should be removed from the toy. F the toy is not used for a long time, please take the batteries out of the toy
7. Do not shortcircuit the power supply terminate.
8. Take out and install the rechargeable battery: Loosen the main battery compartment screws with screwdriver, open the battery cover, connect and pull out the battery connector socket in the correct direction, then close the battery cover, tighten the screws of the battery cover with sCrewdriver, The toy can only be used in water after it is installed in accordance with the instructions.
9. This rechargeable battery is non-replaceable, and the rechargeable battery can only be charged under the supervision of adut
10. Connect the supplied USB charger to the power supply with output vattage of 5.00 24; (such as: US8 mobile phone charger, computer USB interface) to charge the battery
11. During charging, the USB charger will be slightly warm, which is norma:
12. The product can only be charged with the recommended US8 charger, and the US8 charger is nct a toy
13. Regularty check whether the wire, plug, casing and other parts of the USB charger and the recommended charger are damaged If theres any damage, stop using it before it is repaired;
14. Disconnect the US8 charger before cleaning the toy
15. Please do nat disassemble or throw the bad batteries and battery pack into fire or water to avoid accident,
16. The toy must not be used by children under age 3

FCC Statement

• This device com plies with part 15 of the FCC rules. Operation is subject to the following two conditions:
  1. this device may not cause harmful interference
  2. this device must accept any interference received, including interference that may cause undesired operation.
• Changes or modifications not express! y approved by the party responsible for compliance could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection again st harmful interference in a residential installation.
• This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio comm uni cations. How ever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reaorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an out I et on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
• The device has been evaluated to meet general RF expo sure requirement. The device can be used in portable exposure condition with out restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>