DS18 MXRC-BT Marine BT Streaming Audio Receiver with Controls Owner’s Manual

DS18 MXRC-BT Marine BT Streaming Audio Receiver with Controls

General Specifications

• Frequency Response……………………………………….. 20Hz-20KHz
• Signal to Noise Ratio………………………………………………….. 80dB
• Total Harmonic Distortion (T.H.D)  ……………………………… 0.1%
• Channel Separation  ………………………………………………….. 60dB
• Operation Voltage  ……………………………………………….. 1 0V – 15V DC
• BT Wireless Audio Version  ………………………… 5.0 + A2DP
• RCA Line Out (Pre-Amp)………………………………………………. 1 Pair (Left & Right) 2.5 Volts
• Remote Output (Turn-on Signal)………………………………………………. Up to 200mA

Features

• Wireless Connection Range…………………………………………………  up to 35Ft (conditions may vary)
• Aux Line Input………………………………………………… Plug 3.5mm
• USB Player ………………………………………………. Up to 32GB
• Water Resistance Rating ……………………………… IPX5
• UV + Salt Resistance ……………………………………………… YES
• Conformal Coating……………………………………….. YES
• LE D Backlit Push Button………………………………..YES (blue)
• Buttons Material……………………………………………… Rubber

Key Functions

• Power ON/OFF (Short Press)
• USB/BT Mode: PLAY or PAUSE
• AUX Mode: Mute ON/OFF
• RESET (Long Press)
• Source Select (Short Press)
• USB/BT Mode: Previous/Next TRACK (Short Press)
• USB/BT Mode: Fast Forward/Rewind (Press and Hold)
• Adjust Volume Level

Measurements

• Overall Diameter ………………………………………………………. 2.43″ / 61.8 mm
• Overall Depth………………………………………………………. 1.83″ I 46.5 mm
• Mounting Hole Diameter  …………………………. 1. 77″ / 45 mm
• Mounting Depth……………………………………………….. 1.18″ / 30 mm

Wiring Diagram

1. USB Port
   Connect a USB Drive up to 32GB with MP3/WMA Audio files.

2. 3.5mm Jack Audio Input
   Analog Audio Auxiliary input using a stereo plug wire.

3. RCA Pre-Output
   Audio Signal to the external amplifier (White: Left Ch, Red: Right Ch}.

4. Blue Wire
   Remote Output, connect this to the external amplifier.

5. Yellow Wire
   Power +12V, connect this to an Accessory switch or a Master Switch, you could connect it directly to the battery for continuous operation (you could have a risk of battery discharge in long periods of time).

6. Black Wire
   Negative/Ground, Connect this directly to the Negative post or chassis ground.

Installation

Once a suitable location has been determined, drill a 45mm (1-3/4) hole and secure your MXRC-BT using the metal mounting bracket. If the bracket needs to be shortened, remove the appropriate number of breakaway segments using a pair of pliers,

1. The MXRC-BT should be installed by a professional technician.
2. Please read the instructions and operation of the equipment carefully before installing.
3. Make sure to connect first the other wires before power connection.
4. To avoid short circuit; Please make sure all the exposed wire are insulated.
5. Please secure all the wires after installation.
6. Please make the connection to the headunit accordingly to this manual Wrong connection may cause severe damage.
7. This player is only for 12V DC electric systems and please make sure your boat belongs to this kind of cathode grounding electrical system.
8. Please connect the wires rightly. Wrong connection will cause malfunction or damage the electrical system.

FCC Statement

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and
2. this devio must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the party responsible

Tor complance couid void the users authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>