emerio FN-110139.1 Desk Fan Instruction Manual
- June 9, 2024
- emerio
Table of Contents
FN-110139.1 Desk Fan
Instruction Manual
SAFETY INFORMATION
Before use make sure to read all of the below instructions in order to avoid
injury or damage, and to get the best results from the appliance. Make sure to
keep this manual in a safe place. If you give or transfer this appliance to
someone else make sure to also include this manual.
In case of damage caused by user failing to follow the instructions in this
manual the warranty will be void. The manufacturer/importer accepts no
liability for damages caused by failure to follow the manual, a negligent use
or use not in accordance with the requirements of this manual.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Before inserting the plug into the mains socket, please check that the voltage and frequency comply with the specifications on the rating label.
- Incorrect operation and improper handling can lead to faults on the device and injuries to the user.
- In the event of improper use or incorrect handling, no liability can be accepted for any damage that may occur.
- Do not immerse the unit or mains plug in water or other liquids. There is danger to life due to electric shock! However, if this should occur, remove the mains plug immediately and then have the unit checked by an expert before using it again.
- Do not operate the device if the mains cable or the mains plug show signs of damage, if the device has fallen on the floor or has been otherwise damaged. In such cases take the device to a specialist for checking and repair, if necessary.
- Never remove the mains plug from the socket by pulling on the mains cable, or with wet hands.
- Ensure that the mains cable does not hang over sharp edges or allow it to become trapped.
- Keep the appliance away from damp, and protect from splashes.
- Keep the appliance away from hot objects (e.g. hotplates) and open flames.
- Keep the appliance and its cord out of reach of children less than 8 years.
- Use the appliance on a flat, dry and heat resistance surface.
- Never leave the device unattended during use.
- Do not store or operate the appliance in the open air.
- Keep the appliance in a dry place, inaccessible to children (in its packaging).
- Never put fingers or any other objects through the fan guards when the fan is running.
- Never operate the product without the fan guards in place, as serious personal injury may result.
- The appliance must be assembled completely before use.
- Watch out for long hair! It can be caught in the fan owing to the air turbulence.
- Do not point the air flow to the people for a long time.
- After assembly, do not remove the guards during use or cleaning.
PARTS DESCRIPTION
1. Front guard
2. Blade
3. Fixation screws for rear guard
4. Rear guard
5. Handle
6. Grill locking screw
7. Blade fastening screw
8. Motor shaft| 9. Motor unit
10. Oscillation knob
11. Speed control switch
12. Connecting screw and nut
13. Standing shaft
14. Standing base
15. Base locking screw
---|---
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
-
The stand assembly
• Take off the base locking screw (15) from the standing shaft (13).
• Insert the standing shaft into the center hole of standing base (14). Place the base locking screw to the bottom of standing base. Fix the connection of standing shaft by tightening the base locking screw. -
Fan head assembly
• Place the Motor unit (9) on the top of standing shaft. Use the connecting screw and nut (12) to tighten the connection, fixing the fan head onto the pipe. -
Rear guard assembly
• Fit the rear guard (4) onto motor with the handle on the top. Tighten the rear guard with 4 fixation screws (3). -
Fan blade assembly
• Install fan blade (2) onto motor shaft (6) and use the blade fastening screw (7) to fix the blade. -
Front guard assembly
• Put the hook of the front guard (1) onto the top of rear guard.
• Attach front guard to rear guard, close clips and use the grill locking screw (6) to secure the two grilles together.
OPERATING INSTRUCTIONS
- Plug the power cord into a suitable socket.
- Oscillation: To make the fan head oscillate, push down the oscillation knob (10). To stop the fan head from oscillating, pull up the oscillation Knob.
- Tilting Angles: you can adjust the fan to the preferred elevation. Fix the elevation by tightening the connecting screws.
- The fan is switched on by turning the speed control switch on the motor unit, i.e. 0 = OFF, I = low speed,
II = medium speed, III = high speed.
CLEANING
- Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable from the socket.
- Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down with a damp cloth and dry it carefully. Always take out the mains plug first.
- Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50Hz
Power consumption: 35W
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If,
despite all care, damage has occurred during production or transportation,
please return the device to your dealer. In addition to statutory legal
rights, the purchaser has an option to claim under the terms of the following
guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day
of sale. If you have a defective product, you can directly go back to the
point of purchase.
Defects which arise due to improper handling of the device and malfunctions
due to interventions and repairs by third parties or the fitting of non-
original parts are not covered by this guarantee. Always keep your receipt,
without the receipt you can’t claim any form of warranty. Damage caused by not
following the instruction manual, will lead to a void of warranty, if this
results in consequential damages then we will not be liable. Neither can we
hold responsible for material damage or personal injury caused by improper use
if the instruction manual is not properly executed. Damage to accessories does
not mean free replacement of the whole appliance. In such case please contact
our service department. Broken glass or breakage of plastic parts is always
subject to a charge. Defects to consumables or parts subjected to wearing, as
well as cleaning, maintenance or the replacement of said parts are not covered
by the warranty and are to be paid.
ENVIRONMENT FRIENDLY DISPOSAL
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other
household wastes. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe
recycling.
Emerio Switzerland AG
Oberneuhofstrasse 1
6340 Baar
Switzerland
ERP information
Supplier: Emerio Switzerland AG
Oberneuhofstrasse 1
6340 Baar
Switzerland
Declare that the product detailed below:
Information requirements
The mentioned information to identify the FN-110139.1
[Desk Fan]
Description| Symbol| Value| Unit
Maximum fan flow rate| F| 31.| m3/min
Fan power input| P| 34.| W
Service value| SV| 0.93| (m3/min)/W
Standby power consumption| P58| N/A| W
Fan sound power level| LWA| 58.| dB(A)
Maximum air velocity| c| 3.| meters/sec
Measurement standard for service value| EN 50564:2011
IEC 60879:2019
EN IEC 60704-2-7:2020,
EN 60704-1:2021
Contact details for obtaining more
information| Emerio Switzerland AG
Oberneuhofstrasse 1
6340 Baar
Switzerland
Satisfies the requirement of the Council Directives:
COMMISSION REGULATION (EU) No 206/2012 of 6 March 2012 and Amending COMMISSION
REGULATION (EU) 2016/2282 implementing Directive 2009/125/EC of the European
Parliament and of the Council with regard to ecodesign requirements for air
conditioners and comfort fans
Regarding information for consumers on how to install, use and maintain the
product, WEEE information, please check the instruction manual provided with
packaging.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>