AORATY YKB-2057 Portable Wireless Charger User Manual
- June 9, 2024
- AORATY
Table of Contents
AORATY YKB-2057 Portable Wireless Charger User Manual
Overview
This product is designed for portability, we want you to charge your Apple
Watch utterly effortless.
Simply hold the connector near the back of the watch, where magnets cause it
to snap into place automatically.
It charges all Apple Watch models and sizes.
Built-in lithium battery, you can give emergency power to the Apple Watch when
you are outdoors.
Tech Specification
- Input: DC 5V 1 A
- Interface: USB- C
- Capacity: 3.7V 1200 mAh
Operation:
-
Click the power button to turn on the power output, and the battery indicator light turns on, and the Apple watch can be attached to the charging position for charging.
If the charger does not detect the Apple Watch within 35 seconds, it will automatically turn off. -
Double-click the power button to turn off the power
-
Four LED indicators to indicate the current battery capacity, 1 – 4 LEDs indicate the current power is 25%, 50%, 75%, 100%.
-
When only one LED is flashing, it indicates that the battery is too low and needs to be charged.
Plug in the USB-C charging cable, connect the charger, and the battery indicator light starts flashing to indicate that it is charging. The battery indicator shows the current charging capacity.
When all four LEDs are on, the battery is fully charged. -
After the Apple Watch is fully charged, you need to remove the watch and double-click the power button to turn off the power output.
Attention
The magnet attraction of the charging position is the role of the Apple Watch
in aligning the position when charging.
It can’t be used as a function to fix the watch.
Please put it horizontally and do not move when charging.
Do not hang or sway, otherwise the Apple watch may fall off and cause damage.
Caution:
- Please don’t dismantle and remodel the product.
- Pay attention to water-proof, moisture-proof.
- Please don’t charge in hot environment.
- Please stop using immediately if battery is bulge, leaking or smelly.
- Please stop charging immediately when the product temperature is high.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to pan 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which there reviver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the use authority to operate the equipment.
This device complies with Part15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>