Ningbo Everflourish Smart Technology ED26WF-2US1 Dimmer Switch Instruction Manual
- June 9, 2024
- Ningbo Everflourish Smart Technology
Table of Contents
Ningbo Everflourish Smart Technology ED26WF-2US1 Dimmer Switch
Model: ED26WF-2US1 ED26WF-US1
It Works with most dimmable LED bulbs and most incandescent bulbs. It have a convenient button that turns lights on and off , also can brighten or dim the bulbs continuously.Using Wi-Fi technology provides an easy,secure way to achieve remote control.
DIAGRAM
Operation
- Install: Plug the dimmer into socket of AC power,and attach the load with outlet.
- TURN ON/OFF
- Tap botton once: lights turn on
- Tap botton again: lights turn off
- DIM/BRIGHT: Hold down botton —lights will brighten slowly.When brightness is highest,Hold down botton —lights will dim slowly until brightness is lowest.
- WI-FI: Turn on the dimmer,then press botton for six times within three seconds (the sixth press should hold on more than 5 seconds),when the LED indicator starts flash and enter into pairing model. Connect app by phone,and control the dimmer.
Attention
- No use outdoor
- Need dimmable LED light
Specifications
- rated voltage: 125V AC, 60Hz
- Max load: LED 150W; other 300W
Manufacturer
FCC STATEMENT
This device complies with Part 15 of the FCC. Operation is subject to the following two conditions
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Caution: This device complies with Part 15 of the FCC Rules / Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).Operation is subject to the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MPE Reminding
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>