CubCadet 769-26435 Riding Mowers Instruction Manual
- June 9, 2024
- CubCadet
Table of Contents
CubCadet 769-26435 Riding Mowers
The instructions in this supplement sheet replace the instructions in the Installing the Hose section of the Operator’s Manual.
Installing The Hose
-
Thread the upper end of the hose securely into the upper chute support (Rear Bagger) or bag vent (Leaf Collection System). There are two tabs on the lower inside part of the upper chute support/bag vent to allow for secure threading. See Figure 1.
NOTE: Hose and upper chute support/bag vent are left-hand threaded. Thread counterclockwise until secure. -
Install the ring onto the free end of the hose by aligning the start of the hose ribbing with the ring window next to a molded dot and threading counter-clockwise until secure. See the inset in Figure 2.
NOTE: Hose and ring are left-hand threaded. Thread counter-clockwise
until secure.
IMPORTANT! If the ring will not thread onto the hose, carefully trim any extra material on the hose flush to the rib with scissors. -
Lift the hose by the handles on the ring installed in Step 2. Slide hose over boot mounted on the cutting deck, as shown in Figure 3.
-
Make sure the connection is secure and there are no gaps between the hose and the boot.
NOTE: If open, close the bagger cover prior to mowing.
P.O. BOX 361131 CLEVELAND, OHIO 44136-0019.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>