GEPRC GEP-M8Q Multi Functional GPS Positioning Module User Manual
- June 9, 2024
- GEPRC
Table of Contents
GEPRC GEP-M8Q Multi Functional GPS Positioning Module
Product Description
The GEP-MBQ multi-functional GPS positioning module features small size, fast
positioning, stable connection and ease of use; the right circularly polarized
patch antenna provides excellent reception. Built-in QMC5883L high-precision
magnetometer provides accurate orientation pointing; integrated MS5611 high-
precision barometer, subtle altitude changes are not to be missed for more
stable flight. Ideal for use on model products such as FPV drone, multi-rotors
and fixed wing .
Specifications
-
Model: GEP.MBQ
-
Receiving Format: GPS, GLONASS, BDS (Choose GLONASS or BDS)
-
I nput Voltage: 3.3V-5V
-
Channel : 72ch
-
Compass: QMC5883L
-
Barometer :MS5611
-
Baud Rate: 115200bps
-
Output Connector: SH1.0-6P
-
Output Frequency: 10Hz
-
MA Alignment: CW180″flip
-
Speed Accuracy: 0.05 m / s
-
Communication Protocol: UBLOX(GPS), 12C(Mag&Baro)
-
Horizontal positioning accuracy: horizontal <2.SM, SBAS < 2.0M
-
Timing Accuracy: 30 ns
-
Receiving Sensitivity: Trace-162dBrn, Capture-160dBm
-
Dynamic Characteristics: Max
-
Height 50000m, Max Speed: SOOm/s
-
Max Acceleration: 4G
-
Size: 22mm x 22mm x 8.5mm
-
Weight Sg
Wiring Diagram
Installation
The GEP-M8Q GPS module has an integrated magnetometer and barometer, the following should be noted when installing it.
- The GPS antenna must be oriented towards the sky, do not block the antenna.
- The magnetometer must be kept away from magnetic interference in order to work properly, so when installing the M8Q module, be careful not to install it close to places where magnetic interference can be easily generated, such as power lines.
- Do not block the opening of the barometer, otherwise it will not be possible to read the atmospheric pressure data.
- The supplied sponge can be used to cover the top of the barometer to reduce the disturbance of airflow and improve the accuracy of the data.
GPS Setting
-
Open the corresponding port according to the GPS wiring, e.g. port 5 and set
the baud rate to 115200.
-
Turn on the GPS function in the configuration screen and set the protocol to
UBLOX.
-
Restart the flight control after setting up, the flight control will light up the GPS logo after setting to GPS.
Magnetometer & Barometer Settings
-
Set the magnetometer and barometer to QMC5883 and MS5611 respectively in the configuration screen.
-
If the GPS module is mounted in the same direction as the arrow indicates, set the magnetometer orientation to CW 180° flip
-
The flight control will light up when the magnetometer and barometer are set.
-
calibration of the magnetometer according to ground station instructions to ensure that the magnetometer is pointing correctly.
-
Check that the barometer data is levelling off in the sensor interface when at rest
Include
- 1 x GEP-MSQ GPS module
- 1 x SH1 .0-6Pin terminal cable
- 1 x GEP-MSQ GPS user manual
- 1 x GEPRC Sticker
- 2 x heat shrink tube
Contact
Website:http://geprc.com
Facebook
facebook.com/geprc
Official website
www.geprc.com
Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>