DAEWOO WPS301 Motion Sensor Pet Immune Installation Guide
- June 9, 2024
- Daewoo
Table of Contents
MOTION SENSOR
PET IMMUNE
WPS301
DAEWOO SECURITY Alarm system accessories
QUICK INSTALLATION GUIDE
PACKAGE CONTENTS
APPEARANCE DESIGN
INSTALLATION IN THE APPLICATION
-
After having correctly installed your AM301 central to your Daewoo Home Connect control application, you can add your motion sensor WPS301.
To do this, click on “add an accessory + ” from the page of your AM301 central. -
Remove the safety tab from your device or set the switch on the back to on.
-
Install your detector on the wall about 2 meters, 2 meters 20 from the ground. Avoid orienting it facing the floor or placing bulky furniture facing the detector.
Your cat could climb on it and thus trigger your device.
WARM NOTICE
- Do not install the PIR motion sensor outdoors to avoid exposure to rain.
- PIR motion sensors cannot detect motion through glass, such as someone moving outside the window.
- Do not install the PIR motion sensor within 3 feet (1 meter) of heat sources such as electric heaters, vents or fireplaces or other heat sources that may create turbulent air.
- Do not install the PIR motion sensor behind large appliances or furniture that may affect its signal transmission.
- To avoid false alarms, make sure your pets can’t get close to it.
HOW TO INSTALL
As shown above, Install the bracket on the wall with screws. Then put the
motion sensor into the holder.
Adjusts the angle of the motion sensor detection range.
STANDARS
This product bears the selective sorting symbol for waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European Directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are
potentially dangerous of hazardous substances.
In compliance with European Laws. This product is in the essential
requierements and other relevant provisions of Directive 2014/53/EU ( RED )
substances
This product was designed and manufactured in compliance with Directive
2011/65/EU of the European Parliament and of the Council on the restriction of
use of certain hazardous substances in electrical and electronic equipement (
RoHS Directive – RoHS ) and is deemed to comply with the maximum concentration
values set by the European Technical Adaptation Committee ( TAC )
Manufactured in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>