GAGGENAU WSP 222 Warming Drawer Instruction Manual
- June 9, 2024
- Gaggenau
Table of Contents
WSP 222 Warming Drawer
Instruction Manual
WSP 222 Warming Drawer
|
---|---
Please observe
Electrical connection
The appliance must only be connected to a properly installed protective
contact socket. The installation of the socket or replacement of the
connecting cable must only be carried out by a qualified electrician in
accordance with current regulations. The appliance must only be connected with
the power cable provided. Connect the power cable to the back of the
appliance. Power cables with various plug types are available from our after-
sales service.
Do not use multi-plug adapters, power strips or extension leads. There is a
risk of fire in the event of overloading.
If the plug is no longer accessible subsequent to installation, an all-pole
disconnecting device must be present on the installation side with a contact
gap of at least 3 mm.
Fitted units
There must be no rear wall to fitted units which house appliances. There must
be a gap of at least 20 mm between the wall and the base of the unit, as well
as between the wall and the rear wall of theunit above.
The ventilation slots and air intake points must not be covered.
To ensure that they remain uncovered, also observe the installation
instructions for the appliance above.
Installing the appliance
Connect the appliance to the mains. Then align the appliance flush with the
units and screw it in place.
Note: Ensure that the connector lead does not become trapped or bent. After
installation, the connector lead must not be in contact with the back or the
base of the appliance.
After installation, the connector lead must not be in contact with the back or
the base of the appliance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>