NUNOO N1705 Car Multimedia Player User Manual

N1705 Car Multimedia Player
User Manual

Precautions before using the system

Important security information Please read and fully understand the following information before use, and keep this manual next to the product for reference.

• Warning

  • Please install the car player according to the instructions, and contact our technical staff if you encounter any problems during installation.
  • For the personal security of you and others, it is forbidden to watch videos and perform related operations while driving according to relevant national laws and regulations. Please do not watch the screen and do related operations while driving the car.
  • Please take note of all the precautions in this manual and strictly follow the operating instructions
  • Do not tap liquids, as this product may be short-circuited or damaged

Security statement

• The reversing camera function in this system should only be used as an auxiliary reference while driving, so please pay attention to the actual situation.
  Note

• Do not expose this product to moisture.

• The date of the different screens displayed by the main unit must be manually adjusted to display accurately when the product is first turned on and used or when the vehicle has been disconnected and reconnected for use

Ensuring safe driving

• Always obey safe driving regulations and current traffic rules
• Do not continue to use this product if its use, including use of the back-up camera function, interferes with your security and concentration while driving.
• If you need to watch the screen to do so, park the vehicle in a safe place and make sure the parking brake is applied.
• When using this product, do not set the volume too high, or you will not be able to hear the traffic and emergency signals outside the vehicle.
• When the vehicle is running, some functions (such as video playback, etc.) cannot be realized for the sake of driving security. If you need to watch the video while driving, you need to go to the settings to find the Brake Detection option and turn it off

Other security information

• Use the system when starting the engine to prevent battery exhaustion

Introduction to interface definition.

Precautions be fore installation

ACAUTION

• Never install this product in places where, or in a manner that: – Could injure the driver or passengers if the vehicle stops suddenly. – May interfere with the driver’s operation of the vehicle, such as on the floor in front of the driver’s seat, or close to the steering wheel or gearstick.
• To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts are not supplied with this product, use compatible parts in the manner specified after you have the part compatibility checked by your dealer. If parts other than supplied or compatible ones are used, they may damage internal parts of this product or they may work loose and the product may become detached.
• Do not install this product where it may( I) obstruct the driver’s vision, ( II ) impair the performance of any of the vehicle’s operating systems or safety features, including airbags, hazard lamp buttons or ( III) impair the driver’s ability to safely operate the vehicle.
• Never install this product in front of or next to the place in the dashboard, door, or pillar from which one of your vehicle’s airbags would deploy. Please refer to your vehicle’s owner’s manual for reference to the deployment area of the frontal airbags.

Before Installing

Consult with your nearest dealer if installation requires drilling holes or other modifications of the vehicle. Before making a final installation of this product, temporarily connect the wiring to confirm that the connections are correct and the system works properly.

Install ation notes

• Do not install this product in places subject to high temperatures or humidity, such as: – Places close to a heater, vent or air conditioner. – Places exposed to direct sunlight, such as on top of the dashboard. – Places that may be exposed to rain, such as close to the door or on the vehicle’s floor.
• Install this product horizontally on a surface within 0 to 60 degrees tolerance.

dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.

Installation using the sc rew holes on the side o f this product
Fastening this product to the factory radio-mounting bracket. Position this product so shat its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side.

TIP The amount of this unit’s protrusion from the dashboard/console can be adjusted by shifting the position of the screw hole of this unit to the factory radio-mounting bracket.

Factory radio-mounting bracket °If the pawl interferes with installation, you may bend it down out of the way. ()Dashboard or console ®Flush surface screw Be sure to use the screws supplied with this product.

IV.Introduction and operation of the main page features

1. Home key
   Tap this key to return to the main interface;

2. Volume key
   Tap the volume key to display the current volume information; You can adjust the volume \ switch mute \ display the current volume status.

3. Radio mode icon
   Tap the radio mode icon to enter the radio operation interface.

4. Bluetooth mode icon
   Tap the Bluetooth mode icon to enter the Bluetooth operation interface.

5. Backlight mode icon
   Tap the backlight mode icon to switch between day and night or turn off the backlight mode.

6. Displays the device connection status
   Displays the connection status of Bluetooth or USB. When Bluetooth or
   USB is connected, the corresponding icon will be highlighted on the screen, otherwise it will not be displayed.

7. USB mode icon
   Tap the USB mode icon to enter the USB operation interface.

8. Time display
   Displays the current system time; Tap it to switch the clock format \ digital format display.

9. Phone link mode icon
   Tap the mode icon of Phone link to enter the operation interface of
   Phone link;

10. SD card mode icon
    Tap the SD card mode icon to enter the SD card operation interface;

11. Setting mode icon
    Tap the setting mode icon to enter the setting mode for operation;

12. AUX mode icon
    Tap the AUX mode icon to enter the AUX operation interface;

13. FCAM mode icon
    Tap the FCAM mode icon to enter the FCAM operation interface;

14. DSP mode icon
    Tap this DSPicon to Audio regulation

Introduction to radio features and operation

1. Tap this key to browse the stored station information; long-tap this key for one second to search the station from the lowest to the highest frequency, and save the  searched information to the search list, and the list will be refreshed and replaced;
2. Tap this key to cycle through FM > AM > FM modes;
3. Tap this key to switch to stereo/mono;
4. Tap this key to toggle remote/near distance;
5. Tap this key. The frequencies can be moved backward, long- touch for one second to search backward, and automatically stop when a valid station is found.
6. Tap this key. The frequencies can be moved forward, long- touch for one second to search forward, and automatically stop when a valid station is found.
7. Radio Storage Area. 18 stations can be stored in FM and 12 in AM; (AM function is optional).
8. Tap this key to Browse the radio

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>