JBC APS Stand for AP250 Solder Feed Iron Instruction Manual
- June 4, 2024
- JBC
Table of Contents
INSTRUCTION MANUAL
APS
Stand for AP250 Solder Feed Iron
This manual corresponds to the following reference:
AP-SF
Packing List
Features and Connections
Assembly
Cable Collector and Adjustable Tool Holder
Wiper
The integrated wiper offers different ways to clean the cartridge tips.
| Tapping | Wiping | Sponge |
|---|---|---|
| | 
Tap gently to remove excess solder.| Use the slots to remove the remaining
particles.| The softest cleaning method. Keep the sponge damp with distilled
water when orking to avoid tip wear.
Wiper and Brass Wool Replacement
The wiper and brass wool can easily be removed for cleaning or replacement when they are worn.
| 
| 
---|---|---
Lift the wiper at its front edge.| Remove the wiper by pulling
it out.| Replace the brass wool with a new one when it is worn out. Place the
wiper back o replace them if desired.
Accessories
Maintenance
Before carrying out maintenance or storage, always unplug the stand from the station and the tool.
- Use a damp cloth to clean the stand. Alcohol can be used only when cleaning the metal parts.
- Check periodically that the metal parts of the tool/stand are clean so that the station can check the tool’s status.
- Periodically check all cables and tube connections.
- Replace any defective or damaged parts. Use original JBC spare parts only.
- Repairs should only be performed by a JBC-authorized technical service.
Safety
It is imperative to follow safety guidelines to prevent electric shock, injury, fire or explosion.
- Do not use the stand for any other purpose than soldering or rework.
- The power cord must be plugged into approved bases. Be sure that it is properly grounded before use. When unplugging it, hold the plug, not the wire.
- Do not work on electrically live parts.
- The tool should be placed in the stand when not in use in order to activate the sleep mode. The soldering tip, the metal part of the tool and the stand may still be hot even when the station is turned off. Handle with care, including when adjusting the stand position.
- Avoid the contact of flux with skin or eyes to prevent irritation.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protection glasses and gloves when working to avoid personal harm.
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight and also persons with reduced physical, sensory or mental capabilities or lack of experience provided that they have been given adequate supervision or instruction concerning use of the appliance and understand the hazards involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
Specifications
APS
Stand for AP250 Solder Feed Iron
Ref.: AP-SF
– Includes Sleep Mode
– Total Net Weight 1462 g / 3.22 lb
– Package Dimensions / Weight 342 x 155 x 120 mm / 2022 g
(L x W x H) 13.46 x 6.10 x 4.72 in / 4.46 lb
Complies with CE standards ESD safe
Warranty
JBC’s 2-year warranty covers this equipment against all manufacturing defects,
including the replacement of defective parts and labor.
The warranty does not cover product wear or misuse. In order for the warranty
to be valid, equipment must be returned, postage paid, to the dealer where it
was
purchased.
This product should not be thrown in the garbage. In accordance with the European directive 2012/19/EU, electronic equipment at the end of its life must be collected and returned to an authorized recycling facility. a manuales – color gris
www.jbctools.com
0027181-1221
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>