Shenzhen Lechong Technology K3000PRO 3 In 1 Wireless Charging Stand User Manual
- June 9, 2024
- Shenzhen Lechong Technology
Table of Contents
Lechong Technology K3000PRO 3 In 1 Wireless Charging Stand
User Manual
K3000PRO 3 In 1 Wireless Charging Stand
| Working Status | LAD Andleator |
|---|---|
| Connected to power | |
| Standby | |
| On charging | |
| Fully Charged |
1. Metal or abnormal temperature detected
2. Using a non-Quick Charge Wall Charger|
Apple Watch Charging|
For the fast and safe charge, using a Quick Charge 2.0 or 3.0 Wall Charger is highly recommended. Other Chargers may not work well with this device.
Attentions
- Please keep the charger away from water or other liquids.
- Do not place the charger too cbse to any magnetic stripe or clip card (ID card, bank cards, etc.) to avoid magnetic faiure.
- This item is forbidden to be used on any mobile device with metal plates, as it wil cause extreme heat that may burr and / or damage the device.
- Fast charge via the plug and USB charging cable ( both support QC or PD).
- We recommend using the iphone 12/13/14 series mobile phone for bare metal charging or using the original iphone Magsafe magnetic case to charge the iphone 12/13/14 series mobile phone. Wearing other ordinary mobile phone cases may cause the mobile phone to slide down and damage the phone. It is not recommended to charge phones other than the iphone 12/13/14 series because this product is not compatible with other models.
- The standard temperature of wireless charger QI is 130°F, but the temperature of our products should be contrdled within 113°F. The charger wil cut off current when abnormal heating occurs. Please contact us if any damage occurs.
- We recommend that you turn off the power-consumption software before charging to effectively prevent the phone from overheating. When the temperature exceeds 113°F during charging, it is normal for the charging speed to slow down.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note 1: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note 2: 1.Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. The minimum separation generally be used is at least 20 cm.