JVC HA-NP35T Open Ear Wireless Earphones User Manual
- June 9, 2024
- JVC
Table of Contents
JVC HA-NP35T Open Ear Wireless Earphones
Restoring the settings to the initial state
If no sound is heard from one side of the earphones or the earphones cannot be connected to your BLUETOOTH device, restoring the settings of earphones to the initial state may solve the problem. Information of all the paired devices will be deleted (initialized). Perform pairing again from the start. Start by deleting the registration information of this unit from the BLUETOOTH setting on the BLUETOOTH device. Charge the charging case.
- Insert the L and R earphones into the charging case.
- The earphones are charged and the L and R indicators light up.
- The earphones are charged and the L and R indicators light up.
- Press and hold the L touch sensor area for about 15 seconds until the L indicator flashes twice.
- After the indicator has flashed, the earphone is charged and the indicator lights up. If the indicator does not flash, repeat step 2 from the beginning.
- Press and hold the R touch sensor area for about 15 seconds until the R indicator flashes twice.
- After the indicator has flashed, the earphone is charged and the indicator lights up. If the indicator does not flash, repeat step 3 from the beginning.
- Remove the earphones from the charging case and set the L and Rearphones side by side.
- The L and R indicators light up and the power turns on.
- After a while, the L and R earphones are connected to each other and the R indicator starts to flash slowly (once every 5 seconds). Then the L indicator starts to flash quickly and repeatedly.
- The settings are restored to the initial state (factory default).
When the L and R indicators flash quickly, the earphones are now ready for device pairing. Pair the earphones with a device. Pairing (Registering adevice)
- The settings are restored to the initial state (factory default).
When the sound only emits from one side of the earphones even when the earphones are connected to the BLUETOOTH device, touch and hold the touch sensor area on both earphones again to turn off the power and repeat the steps from the beginning.
References
- JVC Contact & Support | JVC
- Top | HA-NP35T | User manual
- Pairing (Registering a device) | HA-NP35T | User manual
- When in Trouble | HA-NP35T | User manual
- Restoring the settings to the initial state | HA-NP35T | User manual
- JVC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>