ALTEC MZX5200 NanoBuds Sport User Guide
- June 8, 2024
- Altec
Table of Contents
MZX5200 NanoBuds Sport
The AL Nanobuds Sport have automatic pairing technology. Once removed from the
case, they will automatically turn on and pair to each other within a few
seconds.
After the earbuds have paired to each other, to connect the earbuds to your
smartphone, go to settings then select the Bluetooth page. Look under
‘available devices’ and connect to “AL Nanobuds Sport”.
Touch Sensor – – – – – ·
Call Microphone, – – – – – – 1 :
”
Place the earb
e Charging (indicator breathing red eve
e Fully charged (indicator breathing blue
0 The LEDs turn off after about 60S
_
to conserve power
···’
TheLEDlndic11torwillfiashwhencha
” ” “”” ···<50llo
··*·<1s–.
· · ·*
eel the USB-C cable into the ng portto chargethe case., e ‘ sainrdiilcyatotoi.nrwdiicllafitaesah
Leh Earbud: Right Earbud: Decrease Volume: Press Once Increase Volume: Press
Once Previous Selection: Press Twice Next Selection: Press Twice Voice
Assistant Press & Hold 2 Sec. Pause/ Play: Press & Hold 2 Sec.
Answer Call: Press Once Answer Call: Press Once Decline Call: Press Twice
Decline Call: Press Twice Hang Up Call: Press & Hold 2 Sec. Hang Up call:
Press & Hold 2 Sec.
the earbud will be reset without losing any pairing information. In unlikely
event that you need to fully reset the earbuds and clear their pairing
information you can do a Hard reset as follows Hard Reset 1. Forget the
earphones in your phone (important). 2. Take ONE earbud out of the case. If
the LED is flashing purple wait for it to go red/blue/red/blue. Now Press and
Hold the earbud touch button for 12S. The LED will change to Red for 5S and
the earbud will reset. 3. Put it back in the case and do the same operation
for the other one
4. Finally take them both out together, the earbuds will flash purple while
they look for each other. Then when they pair together the Primary will go
Red/Blue/Red/Blue (the Secondary LED will turn off). 5. The earphones are now
ready to pair to your phone. 6. Reconnect the earbuds to your phone. You
·ro use Siri or GoogleAssistant, you must have a phone that is compatible with
one of those two voice assistants (iOS or Android, respectively). You must be
within Bluetoothe range to use Siri or Google Assistant via your Wireless
Earbuds. Your Wireless Earbuds will not work with Siri or Google Assistant
ifthe
For additional user materials and warranty Information, please visit
alteclanslng.com
Oianges or modificationsnotertaPJ)IUlebythepartyresponsible for compliance
could void the user’s authority to operate the equipment This device complies
with Part 15 of the FCC Rules. Operation is subject to the following IVo/0
conditions: (1) this device may not causeharmfulInterference. and {2)this
device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply
rth the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates.
uses and can radiate radio frequency energy and. if not installed and used in
accordance with the instructions. may cause harmful interference to radio
cpoamrtmicuulnairciantsiotanlsla. tHioonwever. there is no guarantee that
interference wi!I not occur in a
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>