iCES ICR-230-1 PLL FM Clock Radio User Manual

iCES ICR-230-1 PLL FM Clock Radio

CAUTION:
Be controls or ousted or performance or procedures other than those specified herein may result in hazardous radiaion exposure.

EEP THESE INSTRUCTIONS IN MIND

1. Do not cover or block any ventilation openings. When placing the device on a shelf, leave 5 cm (2″) free space around the whole device.
2. Install in accordance with the supplied user manual.
3. Keep the device away from heat sources such as radiators, heaters, stoves, candles and other heat-generating products or naked flame. The device can only be used in moderate climates.
4. Extremely cold or warm environments should be avoided. Working temperature between 0 and 35 C.
5. Avoid using the device near strong magnetic fields.
6. Electrostatic discharge can disturb normal usage of this device. If so, simply reset and restart the device following the instruction manual. During file transmission, please handle with care and operate in a static-free environment.
7. Warning! Never insert an object into the product through the vents or openings. High voltagee flows through the product and inserting an object can cause electric shock and/or short circuit internal parts. For the same reason, do not spill water or liquid on the product.
8. Do not use in wet or moist areas such as bathrooms, steamy kitchens or near swimmin8 pools.
9. The device shall not be exposed to dripping or splashing and make sure that no objects filled with liquids, such as vases, are placed on or near the apparatus.
10. Do not use this device when condensation may occur. When the unit is used in a warm wet room with damp, water droplets or condensation may occur inside the unit and the unit may not function properly; let the unit stand in power OFF for 1 or 2 hours before turning on the power: the unit should be dry before getting any power
11. Although this device is manufactured with the utmost care and checked several times before leaving the factory, it is still possible that problems may occur, as with all electrical appliances.
12. If you notice smoke, an excessive build-up of heat or any other unexpected phenomena, you should disconnect the plug from the main power socket immediately.
13. This device must operate on a power source as specified on the specification label. If you are not sure of the type of power suply used in your home, consult your dealer or local power company.
14. The supplier is not responsible for damage or lost data caused by malfunction, misuse, modification of the device or battery replacement.
15. Do not interrupt the connection when the device is formatting or transferring files. Otherwise, data may be corrupted or lost.
16. If the unit has USB playback function, the USB memory stick should be plugged into the unit directly. Don’t use an USB extension cable because it can cause interference resulting in failing of data.
17. The rating label has been marked on the bottom or back panel of the device.
18. This device is not intended for use by people (including children) with physical, sensoryyor mental disabilities, ora lack of experience and knowledge, unless they’re under supervision or have received instructions about the correct use of the device by the person who is responsible for their safety.
19. This product is intended for non professional use only and not for commercial or industrial use.
20. Make sure the unit is adjusted to a stable position. Damage caused by using this product in an unstable position vibrations or shocks or by failure to follow any other warning or precaution contained within this user manual will not be covered by warranty.
21. Never remove the casing of this device.
22. Never place this device on other electrical equipment.
23. Do not allow children access to plastic bags.
24. Only use attachments/accessories specified by the manufacturer.
25. Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way, such as the power supply cord or the plug, when liquid has been spilled or objects have fallen into the device, when the device has been exposed to rain or moisture, does not operate normally, or has been dropped.
26. Long exposure to loud sounds from personal music players may lead to temporary or permanent hearing loss.
27. If the product is delivered with power cable or AC power adaptor:

Warning:

• Do not ingest battery, Chemical Burn Hazard” or equivalent working.

• The remote control supplied with] This product contains a coin/button cell battery. If the battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.

• Keep new and used batteries away from children.

• if the battery compartment does not close securely, stop using the product and keep it away from children. if you think batteries might have been swallowed or placed inside any part of the body, other connections have been made.

  • Caution about the use of Batteries:

• The danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

• The battery cannot be subjected to high or low extreme temperatures, or low air pressure at high altitudes during use, storage, or transportation.
  Replacement of a battery with an incorrect type that can result in an explosion or the leakage of flammable liquid or gas.

• Disposal of a battery into a fire or a hot oven, or mechanically crushing or cutting of a battery, can result in an explosion.

• Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or that leakage of flammable liquid or gas.

• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

• Attention should be drawn to the environmental aspects of battery disposal.

Notice
If at any time in the future you should need to dispose of this product please note that:

• All batteries and accumulators need to be removed from this product (Removal of Waste
• Batteries and Accumulators).
• Always bring your product toa professional to remove the buit:-in battery.

1. MUSIC (RADIO) ALARM 1 INDICATOR
2. MULTI-FUNCTION LED DISPLAY
3. BEEPING ALARM 1 INDICATOR
4. SLEEP BUTTON
5. ALARMA voLUME DOWN BUTTON
6. ALARM 2VOLUME UP(+) BUTTON
7. TIME SET
8. PRE/M+BUTTON
9. TUNING-/HOUR SET BUTTON
10. TUNING +/MINUTE SET BUTTON
11. POWER ON/STANDBY/ ALARM OFF BUTTON
12. SNOOZE BUTTON
13. BEEPING ALARM 2 INDICATOR
14. MUSIC (RADIO) ALARM2 INDICATOR
15. SLEEP INDICATOR
16. SPEAKER
17. BATTERY DOOR
18. FM WIRE ANTENNA
19. AC POWER CORD

INSTALLATION

• Unpack all parts and remove protective material.
• Do not connect the unit to the mains before checking the mains voltage and before all other connections have been made.

Radio

1. Press the “ON/OFF” button to turn the clock radio on or off.
2. Adjust the “TUNING” or “TUNING-” to select the desired station.
3. Pres the “VoLUME” or “VOLUME:”button to adjust the volume.
4. Press and hold the “PRE/M#” button until the preset memory display, for example “PO1”, is blinking. Then you can select the desired preset memory by “VOLUME” or “VOLUME-” button and press the PRE/M#” button again to store the desired station.
5. Now you can recall the preset station by pressing the “PRE/ME” button to select the preset memory.

Setting the Alarm

1. You must switch off the radio before you set the alarm time.
2. Press and hold the “ALI” button until the Hour disply begins to blink.
3. You can set the alarm time: Pres the “Hour to adjust the hour and press the “Minute” button to adjust the Minute.
4. Pressthe “AlLI” button now to store the alarm time.
5. Now you can enable the alarm and select to wake up by radio or buzzer by pressing “AL1” in toggle. The LED with the music note logo and bell logo stands for waking up by radio or by buzzer respectively. When both LEDs with the music note logo and the bell logo are off, this means the alarm is disabled.
6. Use the same method to set Alarm 2.

Canceling the Daily Alarm
Pressthe “ON/OFF” button to stop the alarm. The alarm willoperate 24 hours later as per alarm time set.

Disabling the Alarm
Press the “ALl”‘ or “AL2” button in toggle until both LEDs with music note logo and bellogo are of, the alarm is disabled now.

Setting the Clock

1. You must switch off the radio before you set the clock time.
2. Press and hold the “TIME” button until the display begins to blink, then release the button.
3. Press the “HOUR and “MIN” button to adjust the hour and minute.
4. Press the “TIME” button to save the time.

Setting the Sleep Time
Pres the “SLEEP” button repeatedly to set the sleep time (90, 80, 70, 60, 50, 40, 30, 20, 10 min or OFF). When the timer is up, the radio will be switched off automatically.

Snooze
To use the sno02e, press the “SNOOZE” bar when the alarm is sounding. The alarm will stop temporarily, but will resume sounding after 9 minutes.

SPECIFICATIONS

• Frequency Range: FM 87.5-108 MHz
• Power Source: AC 230V 60 Hz, 6W DC2xAAA batteries (For back-up)
• Power Output: 300 mW

Guarantee

Lenco offers service and warranty in accordance to European law, which means that in case of repairs (both during and after the warranty period) you should contact your local dealer. Important note: It is not possible to send products that need repairs to Lenco directly. Important note: If this unit is opened or accessed by a non-official service center in any way, the warranty expires. This device is not suitable for professional use. In case of professional use, all warranty obligations of the manufacturer will be voided.

Disclaimer
Updates to Firmware and/or hardware components are made regularly. Therefore some of the instruction, specifications and pictures in this documentation may differ slightly from your particular situation. All items described in this guide for illustration purposes only and may not apply to particular situation. No legal right or entitlements may be obtained from the description made in this manual.

Disposal of the Old Device
This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, Please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive).

CE Marking
Hereby, Lenco Benelux B.V., Thermiekstraat la, 6361 HB Nuth, The Netherlands, declares that this product is in compliance with the essential EU directive requirements.
The declaration of conformity may be consulted via techdoc@commaxXgroup.comn

Service
For more information and helpdesk support, please visit www.lenco.com Lenco Benelux BV, Thermiekstraat 1a, 6361 HB, The Netherlands.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>