PRT Qutie Portable Label Maker Machine User Guide
- June 8, 2024
- PRT
Table of Contents
Qutie Portable Label Maker Machine
User Guide
Product Introduction
Appearance and Components
Packing List
LED Indicator Status
Button Operation
- Hold down the power button for a few seconds: Turn on/off the printer
- Press the power button: Position and calibrate the location of thermal label paper and heating line
Paper Loading
Place your hands on both sides of the side cover, push upward per the direction shown in the figure to open it.| Load the paper as shown in the figure and make sure the thermosensitive layer faces up.| Close the side cover and pull some extra paper.
App Download
Scan the QR code to download App.
Connection and Printing
- Turn on Bluetooth of mobile phone, then open App, select “Qutie” in the device list. Click “Search device” and find “Qutie-XXXX”, click it to connect.
- Edit the label as need, and then click “Print” after editing.
- Push the cutter button to manually cut the paper.
Note: App operation shall be subject to the latest version.
Battery Charging
When the battery power is low, the red LED indicator will flash slowly. Please charge it by the exclusive USB cable in time. If you continue printing, it may power off automatically.
Note: The printer can be charged via computer USB port or AC adapter. Please note that the AC adapter is not supplied.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
Note: All the drawings of product and accessories in the manual are for
reference only, please subject to the actual product.
Manufacturer: Xiamen Hanin Electronic Technology Co., Ltd.
Address: No.96, Rongyuan Road, Tong’an District, Xiamen, China 361100
E-mail: support@hprt.com
Web: www.hprt.com