Winnix HYR860 Integrated UHF RFID Reader User Manual
- June 8, 2024
- Winnix
Table of Contents
Winnix HYR860 Integrated UHF RFID Reader
Products characteristics
- HYR860 adopts Impinj R2000 module , Max. power output is 30dbm
- Built-in8dbi circular polarization antenna, reading distance up to 10 meters
- Reading speed is 400tags/s
- Standard interfaces as RJ45, RS232, GPIO_IN1, GPIO_OUT2, POE(optional)meet different client’s requirements.
- Standard power supply is 12V DC
- Built-in hardware watchdog and interface protection circuit, suitable for complex industrial
Technical Parameter
Environment requirement
Appearance and structure
- Size(LWH):
- 258mm×258mm×63mm
- Net Weight:
- 1kg
- Gross Weight:
- 2.3kgg
GPIO Interface Definition
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Address: Room635, Ming You Industrial products exhibition center B,
No.168, Baoyuan Road, Xixiang,
Bao’an District,
Shenzhen,
518101,
China.
Tel: (0086)-755-27387953
Web: http://:www.winnix.net
Email: sales@winnix.net