Bestway 60322 Soothing Waterfall LED Instruction Manual

: June 8, 2024
: Bestway

Table of Contents

60322 Soothing Waterfall LED
Battery Precaution
MAINTENANCE
INSTALLATION
Documents / Resources

Model No.60322
Soothing Waterfall LED
Instruction Manual

60322 Soothing Waterfall LED

DC 4.5V Max. 0.3W IP66 Max.ambient: 45ºC
Class 2 circuit
WARNING
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire must be replaced.

Battery Precaution

Do not mix old and new batteries.
Do not mix different types of batteries: alkaline, standard (Carbon – Zinc), or rechargeable (Nickel – Cadmium)
Ensure batteries are installed correctly with regard to polarity (+ and -).
Do not short-circuit the battery.
Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
Rechargeable batteries must be removed from this product before being charged.
Never attempt to disassemble or open batteries as this can lead to chemical burns.
Remove batteries from equipment that will not be used for an extended period of time.
Exhausted batteries should be removed from this product.
Do not dispose of this product and its batteries using fire. Check your local regulations for proper disposal instructions.
Batteries should not be exposed to excessive heat such as sunshine, fire, etc.
Keep batteries out of the reach of children.
Only use AAA batteries (not included).

DISPOSAL
Electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

MAINTENANCE

Store in a dry place when not in use.
LED Battery Assembly

Install 3 AAA batteries (not included).
Press the button once: Turns product on.
Press again: Changes to light show.
Press button and hold for 3 seconds: Turns product off.

NOTE: Keep the product completely dry when you change its batteries. The product will last for up to two hours after being turned on. Then, it will auto power off.

If the waterfall falls over, please re-adjust the angle of the base and tighten the nut.
When the pool is covered, please removed the waterfall.

Bestway 60322 Soothing Waterfall LED - Figure 1

INSTALLATION

Bestway 60322 Soothing Waterfall LED - Figure 2

©2022 Bestway Inflatables & Material Corp.
All rights reserved
Trademarks used in some countries under license from
Marchi utilizzati in alcuni paesi concessi in licenza a Bestway Inflatables & Material Corp., Shanghai, China
Manufactured, distributed and represented in the European Union by
Bestway Europe S.p.a., Via Resistenza, 5, 20098 San Giuliano Milanese (Milano), Italy
Distributed in Latin America by
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: (+61) 2 9037 1388;
New Zealand: 0800 142 101
Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL
Exported by
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
www.bestwaycorp.com

303021302541

Documents / Resources

| Bestway 60322 Soothing Waterfall LED [pdf] Instruction Manual
60322, Soothing Waterfall LED, Waterfall LED, Soothing LED, LED, 60322 Waterfall LED
---|---