VASAGLE RDT118 Dressing Table User Manual
- June 8, 2024
- VASAGLE
Table of Contents
RDT118 Dressing Table
User Manual
General Guidelines
- Please read the following instruction carefully and use the product accordingly.
- Please keep this manual and hand it over when you transfer the product.
- This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.
Notes
-
The item is only intended to be used indoors. Personal injury and/or damage to product may occur if products are used outside of their intended purposes and/or if
products have been changed/modified from their original design. The product must be assembled and used in accordance with the provisions of the manual. The
seller does not assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper use. -
It is recommended that assembly is undertaken by at least 2 adults and an electric drill prepared to facilitate the assembly. Please read assembly instructions
before assembly and strictly adhere to each step outlined. -
If there is/are defective and/or missing part/s after unpacking, please cease assembly immediately and get in contact with us.
-
Please assemble the item in a spacious room and do not place the unwrapped product directly on the ground to avoid damage.
-
Please be careful during the assembly to avoid scratches from any sharp edges.
-
Please do not stand, sit or put heavy stuff on the wooden boards or other parts before assembly.
-
Please match the corresponding board and fitting based on the part number in the manual.
-
If the board does not match with the fitting, please check the pieces as specified in this manual.
-
Please refer to the diagram during assembly. Align and hand tighten all screws in their associated pre–drilled holes first before tightening each screws.
-
Please note that each type of screw has a spare screw.
-
Please do not stand or sit on the product.
-
Please remove all items on the product before moving.
-
Please place it on horizontally level ground.
-
Periodically inspect screw tightness while the product is in use. If necessary, retighten to ensure structural integrity.
-
Do not expose product to direct sunlight or rain; and do not put it in a humid place. Failure to do so may accelerate the distortion, discoloration or cause fissures.
Never touch with sharp objects or corrosive chemicals, which may damage the surface of the item. -
For daily care, please clean with a damp cloth then immediately wipe dry.
Warnings
- It is not intended for use by children under 3 years of age. Children must be under adult supervision to use the product.
- It is forbidden children to climb or play on the product to avoid serious body injury caused by the toppling.
- During the assembly process, keep any small parts out of the reach of children. It may be fatal if swallowed or inhaled.
- To avoid the potential dangers of suffocation, please keep all parts and packaging (films, plastic bags and foam, etc.) away from babies and children.
RDT118 Dressing Table
Tools Required:
| Bolt
---|---
| Connecting piece
Adjust connecting piece direction until it is properly lined up with the hole.
Insert bolt when connecting piece direction is properly lined up.
Tips
If there is any damage after unpacking or you have any questions during assembly, please feel free to contact us at your earliest convenience. Our customer care team provides professional returns or exchanges as well as assembly guidance. By tightening these two screws, you can adjust the position of the front, back, left, and right of the board so that the board is in a proper position.
Version QM:3.0
Stand:22.09.2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>