2007-2011 Honda CR-V Behind 2nd Row Seats Rear Barrier Divider Instruction Manual

: June 8, 2024
: Honda

Table of Contents

Installation
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

2007-2011 Honda CR-V Behind 2nd Row Seats Rear Barrier Divider

2007-2011 Honda CR-V Behind 2nd Row Seats Rear Barrier
Divider

Installation

NOTE: Many newer models have B-pillar handles and even overhead on the ceiling that can be used for some of the top mounting locations. Check to see if you prefer to use these factory locations as the nets typically have enough adjustment to allow for this option. If your vehicle does not have handles in desired locations or you prefer to install mounting points for better fitment, please follow the below steps.

IMPORTANT: READ INSTRUCTIONS FULLY BEFORE STARTING

Time: About 1 ½ to 2 hours
Paw Level:
Tools: (may vary by vehicle)
Tools: Metric Sockets and wrench set
Drill & bits
Punch
Small hammer
Phillips bits for power drill
panel removal tool.
May need: Small marker Dremel or plastic trimming tool such as saw or snips
Please watch this preliminary video for detail on C100 Mount kit: https://vimeo.com/321352161

Step 1 Fold down and then forward the back seats to make working easier. Pop off by hand or use panel removal tool to gently lift and remove upper seat belt roller cover

Step 2 Unbolt the bolt and drop the seat belt assembly out of the way

Step 3 Carefully grasp and pop the lower, darker colored plastic housing covering the wheel well. Watch for any hidden screws and go slowly. Model years can be slightly different from example shown. The lower panel just needs to be loosened, not completely removed fromcar. Then loosen and remove the top lighter section as shown:

Step 4 Exposed C pillar area where the C100M mounts will be installed for the top of the barrier net

Step 5 If you have not already, we recommend watching the C100M video for detail on installing these type mounts: https://vimeo.com/321352161

Step 6 Following guidelines outlined in video regarding double checking depth and avoiding wires and washer lines, Install the C100M just above the leading top corner of the side quarter windows

Driver’s side:

Passenger side:

Step 7 Once the C100’s are installed, test fit the lighter panels and mark and trim (if necessary) inner plastic for strap clearance

(passenger side shown):

View from inside of the panel:

Step 8 Reassemble trim panels with strap and D ring over top of trim

Step 9 Install the upper seat belt bolts with the C1015 brackets installed as shown on the driver’s side

Step 10 Install the net loosely, working top to bottom. Top straps to the C100M D rings, middle straps to the C1015 brackets and then lowest straps under the pivot point for the rear seat back upright

Lower Area:

Step 11 Do final tensioning from top, then lower (check that the rear seat can raise and lower)

Step 12 Once net is centered, wrap and tie up the excess ends: Video showing detail of process:

Step 13 Check out our dog training and introduction tips for success: Click here to learn more about dog training and safety when using these nets.

Enjoy your Raingler Net. Keep your gear stowed safely in back and your pups in place! Let us know if any comment or questions and tag us when you’ve got your net in use and action!