TECOM AG-868 Kanban System Installation Guide
- June 8, 2024
- TECOM
Table of Contents
AG-868 Kanban System
Installation Guide
AG-868 Kanban System
Kanban System (AG868 + VB168) Quick Installation Guide
AG-868 Settings
1. Use an Ethernet cable to connect PC/Notebook’s Ethernet port to AG868 LAN
Port (Yellow color).
2. Open a browser and key in “192.168.168.10”, and key in “admin” for
Username, “IP585xAdmin” for Password, then click “Sign in” to enter the
management page of AG-868 Gateway.
3. Setup the
Motor and VB-168 Vibration Temperature Sensor
i. Click “Settings” → “RS485” → “Motor” → “Add” to enter Motor information
page.
ii. Key in
detailed Motor information as picture below. 
iii. Click “Save” to save this page after Motor information
data is filled. 
iv. Click “+” to
add VB-168 Vibration and Temperature Sensor.
v. Select “Bluetooth” for “Line” field, key in ID of VB-168. (The ID
of VB-168 is on the side of the device.) Y-axis and Z-axis settings are the
same as X-axis settings.
vi. Key in parameters for Temperature and click ‘Save” as picture
below. 
vii. Install
battery into the VB-168 Vibration Temperature Sensor, and you will see the
VB-168 Sensor is added in the list as picture below.
4. Connect with Smartphone APP
i. Click “Settings” → “Unit Pairing” → “Add” to pair a Smartphone.
ii. Check the box at the Select field of
the newly added device, and then click “Edit”.
iii. Edit the Unit (smartphone) Information
○1 Name: User-selected name
○2 Type: Smart Phone
○3 Account: Assign an account in the range 100 ~ 119
○4 Password: Any three digits
Then click “Save”.
Note: When Smartphone APP registers with this AG-868 Gateway, the
“Account” and “Password” set in the Smartphone APP need to be the same as the
“Account” and
“Password” set here.
iv. Click “Start Pairing”
When the registration information from a Smartphone APP is
consistent with the Unit Information of this item, the Smartphone APP would be
registered with this AG-868 Gateway.
Install AG-868 TV APP (Tecom UPI) on TECO 50 inch Android TV (TL50U12TRE)
1. Android TV Specification requirement: Android system 5.0 or above.
2. Connect TV’s Wi-Fi to AG-868 Gateway’s Wi-Fi SSID : Tecom_XXXXXX, “XXXXXX”
is the last 6 digits of MAC address. (MAC address is on the label which is on
the side of AG-868 Gateway.)
3. Insert AG-868 TV APP (Tecom UPI) software USB drive to
the USB port of TV.
4. Open “Media Player” and enter USB drive, choose
“IOM_AG868_V0.x_xxxxxx_TV.apk”.
5. Choose “INSTALL” to install Tecom UPI APP.
6. Choose “OPEN” to execute Tecom UPI
APP.
7. After the
Tecom UPI app is installed on the Android TV, the screen is as shown in the
picture below. All VB-168 devices are displayed on the left of the TV
homepage. 30
pieces of VB-168 can be assigned and programmed by an AG-868 Gateway. 
8. If there is an alarming VB-168, it will be moved forward. The vibration
and temperature data measured by the VB-168 device that is alarming will be
displayed on the right of the TV homepage. If there are multiple VB-168
devices that are alarming, it will be displayed in a scrolling manner.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>