UNIMAX GN819-00980 Wireless Charger Unit User Manual

P/N:Wirless Charger Unit/ft#i
M/N:GN819-00980
Brand:UNIMAX
FCC : 2AO4C-WLCD03BW
Brand: Unimax
540 6-4. Using the other interior features

GN819-00980 Wireless Charger Unit

cle has been parked in the sun
About connected external devices
Depending on the connected exter­ nal device, charging may occasion­ ally be suspended and then start again. Th s is not a malfunction. ‘he fol’owing is a sample
Wireess charger item in the manua explanatory text image diagr an

NOTICE
To prevent damage to the USB charging ports

• Do not insert foreign objects into the ports.

• Do not spill water or other liq­ uids into the ports.
  When the USE charging ports are not in use. close the lids. If a foreign object or liquid enters a port may cause a short circuit,

• Do not apply excessive force to or impact the USE charging ports.

• Do not disassemble or modify the USB charging ports,
  To prevent damage to exter­ nal devices

• Do not leave external devices in the vehicle. The temperature inside the vehicle may become high. resulting in damage to an external device.

• Do not push down on or apply unnecessary force to an exter­ nal device or the cable of ar external device while it is con­ nected.
  To prevent battery discharge

• Do not use the USB charging ports for a long period of time when the engine is off.

Wireless charger (if equipped)
A portable device can be charged by just placing Qi stan­ dard wireless charge compatible portable devices according to the Wireless Power Consortium. such as smartphones and mobile batteries. etc •. on the charge area.
This function cannot be used with portable devices that are larger than the charging area. Also, depending on the portable device, it may not operate as normal. Please read the opera­ tion manual for portable devices to be used.
The “Qi” symbol
The “Qi” symbol is a trademark of the Wireless Power Consor­ tum.

” Meeting RF exposure requirements with compliance distance at 0 cm.”

■ Name for all parts

: A Charge area
B Operation indicator light
C Power supply switch
■ Using the wireless charger

1. Press the power supply switch of the wireless char­ ger.
   Switches on and off with each press of the power supply switch.
   When turned on, the operation indi­ cator light (green) comes on.
   Even with the engine off, the on/off state of the power supply switch is memorized.

2. Place the charging side of the portable device down. When charging, the operation indi­ cator light (orange) comes on.
   If charging is not occurring, try plac­ ing the portable device as close to the center of the charging area as possible.
   When charging is complete. the operation indicator light (green) comes on. ■ Recharging function
   e When charging is complete and after a fixed time in the charge suspension state. charging restarts.
   • When the portable device is moved, charging is stopped for a moment and then it restarts,
   ■ Lighting conditions of oper■ ation indicator light

When charging is com- plete
Operation indicator light| Conditions
Orange (comes on)| When placing the por­ table device on the charging area (detect­ ing the portable device)
Charging

: Depending on the portable device, there are cases where the operation indicator light will con­ tinue being lit up orange even after the charging is complete,

• When the operation indicator
  I ight flashes
  When an error occurs. the operation indicator light flashes an orange color.
  Hand le the error based on the following tables.

• Flashing repeatedly once every second (Orange)

• Repeatedly flashes 3 times continuously (Orange)

A foreign sub- stance is between the por­ table device and
charge area,| Remove the for­ eign substance ­ from between portable device and the charge area.
The portable cevice is out of sync due to the device being
shifted from the center of the charge area,| Place the porta­ ble device near the center of the charge area.

• Repeatedly flashes 4 times continuously (Orange)

start charging again after for a while.

The wireless charger can be operated when The engine switch is in ACC or ON,

• Usable portable devices
  Qi standard wireless charge stan­ dard can be used on compatible devices,
  However, not all Qi standard devices and compatibility are guar­ anteed.
  Starting with mobile phones and smartphones, it is aimed for low power electrically supplied portable devices of no more than 5W.

• When covers and accessories are attached to portable devices Do not charge in situations where cover and accessories not able to handle Qi are attached to the porta­ ble device, Depending on the type of cover and accessory, it may not be possible to charge. When charging is not performed even with the portable device placed on the
  charge area, remove the cover and accessories.

• While charging, noise enters the AM radio
  Turn off the wireless charger and confirm that the noise has decreased, If the noise decreases, continuously pushing the power supply switch of the wireless char­ ger for 2 seconds. the frequency of the charger can be changed and the noise can be reduced.Also, on that occasion, the operation indicatorlight w II flash orange 2 times,

• Important points of the wire­ less charger
  If the electronic key cannot be detected within the vehicle inte­ rior, charging cannot be done.
  When the door is opened and closed, charging may be tempo­ rarily suspended.
  When charging, the wireless charging device and portable device will get warmer. however this is not a malfunction.
  When a portable device gets warm while charging, charging may stop due to the protection function on the portable device side, In this case, when the tem­ perature of the portable device drops significantly, charge again.

Operation sounds

When the power supply is turned on, while searching for the portable device a sound will be produced however this is not a malfunction.

A WARNING

• Caution while driving
  When charging a portable device, for safety reasons, the driver  should not operate the main part of the portable device while driv­ing.

• Caution regarding interfer­ ence with electronic devices People with implantable cardiac pacemakers, cardiac resynchroni­ zation therapy-pacemakers or implantable cardioverter defibrilla­ tors, as well as any other electri­ cal medical device, should consult their physician about the usage of the wireless charger. The opera­ tions of the wireless charger may have an affect on medical devices.

• To prevent damage or burns Observe the following precau­ tions.
  Failure to do so may result in a possib lity of equipment failure and damage, catch fire, burns due to overheat,

• Do not insert any metallic objects between the charging area and the portable device while charging

• Do not attach stickers, metallic objects, etc., to the charger area or portable device
  Do not cover with cloth, etc.. and charge Do not charge portable devices other than designated

• Do not attempt to dismantle for disassembly or modifications

• Do not hit or apply a strong force

NOTICE

• Conditions in which the func­ tion may not operate cor­ rectly
  In the following conditions, it may not operate correctly

• The portable device is fully charged
  There is foreign matter between the charge area and portable device
  The temperature of the portable device gets higher from charging
  The charging surface of the por­ table device is facing up

• The placement of the portable device is out of alignment with the charge area

• Near a TV tower. electric power plant, gas station, radio station, large isplay, airport or other facility that generates strong radio waves or electrical noise @ When the electronic key is in contact with, or is covered by the following metallic objects

• Cards to which aluminum foil is attached

• Cigarette boxes that have alu­ minum foil inside

• Metallic wallets or bags

• Coins

• Hand warmers made of metal

• Media such as CDs and DVDs

NOTICE
e When other wireless keys ((hat emit radio waves) are being used nearby
In addition, excluding the above­ mentioned, when the charger does not perform normaly or the operation display lamp is flashing continuously il is considered that the wireless charger is malfunc­ tioning, Contact authorized Toyota dealer,
To prevent failure or damage to data

• Do not bring magnetic cards, such as credit cards, or mag­ netic recording media, etc,, close to the charger while charging, otherwise, data may disappear under the influence of magnetism, Also, do not bring precision instruments such as wrist watches, etc., close to the charger. as such objects may break,
• Do not leave portable devices in the cabin, The temperature inside the cabin may become high, when under the sun, and cause damage to the device,
• To prevent battery discharge When the engine is stopped, do not use the wireless charger for a long time,

[res
Fold down the armrest for use,

NOTICE
To prevent damage to the armrest
Do not apply loo much load on the armrest
[Assist gins
An assist grip installed on the ceiling can be used to support your body while sitting on lhe seat.

l WARNING
Assist grips
Do not use the assist grip when getting in or oul of the vehicle or rising from you seat,

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1 )This device may not cause interference; and
(2)This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>