XPLOR PHR19 Headlamp Instruction Manual

XPLOR PHR19 Headlamp
Instruction Manual
GP

Basic Featured

Getting to know your headlamp

(A) Button A
(B) Button B
(C) Bracket
(D) Floodlight| (E) Unscrew battery cap to change battery- insert +/-
(F) Battery/Charge indicator
(G) Unscrew to access the USB-C charge port
(H) Spotlight
---|---

Operating instruction

Spotlight

• Single press (A) to cycle through settings. Low > Med > High > Ultra-High > Off
• Double press (A) at any time to turn off and memorizes the last selection.

Flood light

• Single press (B) to cycle through settings. Ultra-low > Low > Med > High > Off
• Double press (B) at any time to turn off and memorized the last selection.

Turbo

• Press and hold (A) or (B) for > 1 sec to activate Turbo mode from any light setting.
• Double press (A) or (B) to turn off settings.

SOS & Beacon

• To activate SOS, press and hold (A) or (B) for 5 sec to activate SOS. Activation can be from off or when already on.
• To activate Beacon, press (A) and then press (B) or press (B) and then press (A).
• Press (A) to return to the low spot only.
• Press (B) to return to ultra-low flood only.
• Double press (A) or (B) to turn off all settings.

Lock-out

• Lock – Press (A) and (B) simultaneously for 3 seconds — LED battery red indicator flashes twice to confirm lock-out is activated.
• Unlock – Press (A) and (B) simultaneously for 3 seconds — LED battery green indicator flashes twice to confirm lock-out de-activated.

Battery indicator

• When the headlamp is off double-press (A) or (B) to check the battery level.
  Solid green| Over 70%
  ---|---
  Solid red| 35% to 70%
  Red flashes 3 times| Below 35%
• Low warning indicator – When the battery is below 35%, the light in use will flash twice every minute. Over-heat protection The output will drop down one step if overheating occurs to protect the headlamp.

Specifications

Weight: 137g (with 18650 battery)
Dimensions : 91.5 x 52.2 x 42 mm
LED: OSRAM LED
Material: Die-cast aluminum
Circuit: Digitally regulated
Battery : 1 x 18650 Li-ion battery or 2 x 3V CR123A
Battery protection: Over-charge and over-discharge

Note

1. The above specifications are tested by GP internal laboratory using GP 18650-26FCP 3.6V 2550mAh rechargeable Li-ion battery at temperature 20 – 25°C and humidity ranging from 40% -80%.
2. The performance may vary according to working environments and actual battery conditions.

Usage and Care

• Do not dismantle the headlamp as this can cause harm to the headlamp and the person and will void the warranty.
• This has a high lumen output so do not shine directly into anyone’s eyes as it may cause harm and injury.
• Use suggested batteries for this product for your own safety.
• Do not use cleaning agents that may damage the products. Use a soft cloth to avoid scratching.
• When charging always connect the charge port carefully to avoid water and other liquids getting into the port which may cause damage to the unit and battery.
• Seek medical advice immediately if a battery has been swallowed.
• In the event of a cell leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.
• When possible, remove the battery from the equipment when not in use.
• Dispose of battery properly.

Caution

• Charging incorrect type batteries may lead to an explosion, battery rupture or leakage, personal injury, or property damage.
• Do not dispose of batteries in a fire or a hot oven, or mechanically crush or cutting of a battery that can result in an explosion.
• Leaving a battery in an extremely high temperature or low air pressure surrounding environment can result in an explosion or the leakage of flammable liquid or gas.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>