Shenzhen Cms Photoelectric Technology Science FGD-0001-01 RGB Flood Light User Manual
- June 4, 2024
- Shenzhen Cms Photoelectric Technology Science
Table of Contents
Shenzhen Cms Photoelectric Technology Science FGD-0001-01 RGB Flood Light
Product Parameters
- Product Name: RGB Flood Lights
- Output Voltage: DC24V
- Adapter lnput:AC100-240V
- Output:DC24V,2A
Packing Lists
- DFlood Lamp 4PCS/6PCSGround
- Stake 4PCS/6PCS
- Remote lPCS
Installation Instruction
Adapter
Screws Remote Power Wire Stake
Before installation, please open the package and check all the component to make sure all the parts are included.
Installation Ways as Picture
Ground Stake Installation
Wall mounting installation
After confirming the installation position of the floodlight, connect the 4-hole female plug on the main power line with the 4-pin male plug on the RGB floodlight in sequence, and tighten the protective rubber sleeve.
Connect the adapter with the main power wire and plug it into the
outlet.
Remote Function
There are 24 function buttons on the remote control, and the corresponding functions are defined as follows
When the remote control is not used, there is a physical button on the adapter which can also realize the function of the 10th, 12th, 13th, 14th, 15th, 16th, 17th, 18th, 19th, 20th, 21st, 22nd, 23rd and 24th button, press it once, it is the mode of the 10th button, and press it again, it is the 12th button’s mode, and so on, and so on, repeating the cycle.
Caution
- During the installation, please handle the lamp carefully, do not pull the connecting wire of the lamp.
- Do not place the lamp into the water depression or near the drainage area, it will cause the lamp damage.
- Please note the adapter is not waterproof.
- Pay attention to protecting the waterproof joints(Female/Male) on the lamps.
- Do not enter the dust and water.
- Be careful not to be lost and destroy the sealing ring on the waterproof joint, and you should not take illegal operations such as cutting off waterproof joints.
- All wiring and installation work are strictly prohibited with electricity operations.
- lf you need to use tools during the installation process, you must use the tool correctly and ensure safely.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. f this equipment does cause harmful interference to radio or
television reception, which can be determined by turning thee equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected Consult the dealer or an experienced radio/TV technician
for help. Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition, compliance with exposure
requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>