Ketcham ORB-24 Orbit Series 24 Inch Round LED Mirror Instruction Manual
- June 9, 2024
- Ketcham
Table of Contents
Ketcham ORB-24 Orbit Series 24 Inch Round LED Mirror Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical product, basic precautions should always be folllowed, including the following:
WARNING:
To reduce the risk of burns, fire, electric shock, injury or death, use this product only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop or insert any object into any opening. Do not use outdoors.
WARNING:
Installation should be done by a licensed professional. Failure to follow proper installation will void warranty.
WARNING:
Risk of electric shock. Connect this product to a properly grounded circuit only. See grounding instructions below.
Grounding Instructions:
This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the product
WARNING:
An electrical option mirror must be wired to a 20 Amp GFI (Ground Fault Interrupter) protected circuit when used in bathrooms and all other locations required by the National Electric Code.
Dimension
| 24”| 30”| 36”
---|---|---|---
A| 24”| 30”| 36”
C| 12”| 15”| 18”
X| 10 1/4”| 16 1/4”| 22 1/4”
Y| 11 5/6”| 17 5/6”| 23 5/6”
- A. – Mirror’s Diameter |
- C .- Distance from Mirror Frame to Electrical Box
- X .- Distance Between Top Bolts |
- D. stance Between Bottom Bolts
Instaillation
FINAL ASSEMBLY
DOES YOUR MIRROR HAVE VISIBLE TOUCH SENSORS ON THE FACE OF THE MIRROR?
Adjusting Kelvin Temperature:
To change the Kelvin temperature, simply double tap the sensor.
Kelvin temperature options are: 3000K, 4500K, and 6000K.
Adjusting the Brightness:
To adjust the brightness, hold down the sensor and it will begin to fade down.
To increase the brightness, tap and hold the sensor again.
Operating the Defogger:
To turn on the defogger, tap the sensor. When you hear a click, the defogger is now turned on. The defogger will take approximately 5 minutes to heat up. To turn off the defogger, tap the touch sensor again, and you will hear defogger unit click off.
NOTE: IF YOUR MIRROR DOES NOT HAVE VISIBLE TOUCH SENSORS ON THE FACE OF\
THE MIRROR, IT MUST BE HARDWIRED TO A LIGHT SWITCH.
these models do not have color changing, dimming, or defogging capabilities.
Use and Maintenance:
CLEANING A STANDARD MIRROR SURFACE:
- Mirror and mirror body are constructed of mirrored glass and aluminum. Use a damp cloth to clean your mirror. Do not use any abrasive material as it may damage the surface and finish of the mirror.
- A mild detergent may be used to clean the surfaces of the mirror.
- When cleaning, spray the cloth, not the mirror or surrounding surfaces.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>