dmf H3SO H-Series New Construction with Screws Instruction Manual
- June 9, 2024
- dmf
Table of Contents
dmf H3SO H-Series New Construction with Screws
Safety Information
For your safety, read and understand these instructions completely before
starting installation.
The electrical product contained herein is designed to meet the requirements
of UL 1598 and the current NFP regulations as published in the NEC. Specific
modifications and revisions in your area may differ from this standard.
Compliance with local building and electrical codes must be confirmed before
installation.
WARNING – To prevent wiring damage or abrasion, do not pinch or damage
exposed wiring during installation. Keep away from the edges of sheet metal or
other sharp objects.
WARNING – Risk of fire or electric shock. Installation of this product
requires a person familiar with the construction and operation of the
luminaire’s electrical system and the hazard involved. If not qualified, do
not attempt installation. Contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this kit only in the
luminaires that have the construction features shown in the photographs and/or
drawings. Do not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
WARNING – Risk of fire or electric shock. Do not alter, relocate or
remove the wiring, lamp holders, power supply, or any other electrical
component.
Pre-Installation
Power to the luminaire must be turned off prior to installation. Failure to do so may cause electric shock, which may result in injury or death. Ensure that the electrical connection is in accordance with local and NEC standards and that the wiring is 120VAC.
Housing Installation
-
Locate fixture position and locate AC pigtail.
-
Align housing to the bottom of the joist using alignment tabs.
-
Install both wood screws (factory installed) into the joist.
Note: Housing must be held securely against the joist to ensure proper installation. -
Route electrical wires through the wiring compartment using Romex tabs or knockouts.
-
Connect hardwire adapter (included) to housing electrical leads.
-
Mark center fixture position on drywall.
-
Cut an opening in drywall and install drywall (housing is compatible with ceiling thickness 1/2″ to 5/8″).
Cut out: H3SO: 3 1/2″ [89mm], H4SO: 4 1/2″ [114mm]
Module Installation
- Align trim onto module and snap on trim.
- Make ground wire connection and attach ground wire terminal (factory installed on module) to junction box per national and local electrical code.
- Connect module connector.
- Place module into housing. Push trim up until flush with ceiling.
- Press trim to ceiling and rotate 1/4 turn to fully seat trim.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>