DMF Lighting H4TRFWHMC 4 Inch White Recessed Light Flush Instruction Manual
- June 12, 2024
- DMF Lighting
Table of Contents
H Series
Residential Lighting
Installation Instructions
Module for use with H3 or H4 Series luminaire model(s), manufactured by DMF Lighting. Retrofit Kit for use with deep 4O or deep 4″ round junction box in accordance with instructions provided. See dmflighting.com/compatibilityhseries for additional info.
Safety Information
For your safety, read and understand these instructions completely before
starting installation.
The electrical product contained herein is designed to meet the requirements
of UL 1598 and the current NFP regulations as published in the NEC. Specific
modifications and revisions in your area may differ from this standard.
Compliance with local building and electrical codes must be confirmed before
installation.
WARNING – To prevent wiring damage or abrasion, do not pinch or damage
exposed wiring during installation. Keep away from edges of sheet metal or
other sharp objects.
WARNING – Risk of fire or electric shock. Installation of this retrofit
assembly requires a person familiar with the construction and operation of the
luminaire’s electrical system and the hazard involved. If not qualified, do
not attempt installation. Contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this kit only in the
luminaires that have the construction features shown in the photographs and /
or drawings. Do not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
WARNING – Risk of fire or electric shock. Do not alter, relocate or
remove wiring, lampholders, power supply, or any other electrical component.
Pre-Installation
Power to luminaire must be turned off prior to installation. Failure to do so may cause electric shock, which may result in injury or death. Ensure that electrical connection is in accordance with local and NEC standards.
Installation
Brightness Switch
| Ambient Light: 350 lm (5W)
---|---
| 7-9 ft Ceiling: 750 lm (9W)
| 9-12 ft Ceiling: 950 lm (12W)
- Set Brightness Switch to desired setting.
- Align trim onto module and push trim until tension clips snaps into place.
- Attach module ground wire to building ground per national and local electrical code.
- Connect module power connector.
- Place module into housing. Press trim to ceiling and rotate ¼ turn to fully seat trim.
Have a question? Contact us!
323.934.7779
info@dmflighting.com
Documents / Resources
| DMF
Lighting H4TRFWHMC 4 Inch White Recessed Light
Flush
[pdf] Instruction Manual
H4TRFWHMC 4 Inch White Recessed Light Flush, H4TRFWHMC, 4 Inch White Recessed
Light Flush, White Recessed Light Flush, Recessed Light Flush, Light Flush
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>