electro-harmonix SPORT BUDS V2 EHX Wireless Bluetooth Earbuds User Manual

: June 9, 2024
: electro-harmonix

electro-harmonix SPORT BUDS V2 EHX Wireless Bluetooth Earbuds

Getting Started

Power on

Press and hold the Multifunction Button (MFB) for 3 seconds to power the EHX Sport Buds 2. Upon powering on, you will hear an ascending guitar lick audio prompt

The headset needs to be fully charged prior to first-time use.

Fitting & Wearing

Ear Cushion Sizes

Gently push the earbud into your ear canal, and adjust the ear hook for a comfortable fit.

Pairing

The EHX Sport Buds 2 automatically enter pairing mode upon powering on unless a previously connected device, such as a smartphone or tablet, is present The LED indicator at the front of the Right ear bud flashes red and blue while in pairing mode. If paired before, the headset will automatically connect to your device when ~ powers on. An audio prompt – MEL9 CHOIR sound – is heard upon a successful pairing.

To connect, activate Bluetooth® mode on your device, then select EHX Sport Buds 2 when ~ appears on the device list.

Reset

Power down the headset by holding the MFB button for 3 seconds. You will hear a descending guitar lick audio prompt indicating power is off.
Remove the headset fi”om your device’s Bluetooth® list.
Disable, then re-enable Bluetooth® on your device (this might not always be necessary depending on the device).
Power on the headset and pair why your device.

Charging

When the battery level is low, you will see the LED indicator flash red and hear an audio prompt – Mechanical Dive guitar lick – in the earbuds.

General Functions

Answer/ End a Call

When there is an incoming call, the earbuds pause your audio program and play a phone ring audio prompt the LED flashes blue. Tap the MFB once to answer; tap it again to end the call.

Reject a Call

Upon receiving an incoming call, hold the MFB for 1 second to reject the call.

Redial the Last Number

While the headset is connected, tap the MFB twice to redial the last number called.

Voice Assistance

Hold the MFB down until you hear an audio prompt: DING. Release the MFB once the audio prompt Ding is heard. The voice assistance function of your device (e.g., Sir’®) is now activated.

Previous/NeXT Track

While playing music, hold the+ Volume button for 1 second to return to the start of the current track or go back to the previous track. Hold the – Volume button to advance to the next track.

Adjust Volume

When on a call or playing music, tap either the+/- Volume button once.

Play/Pause

While playing music, tap the MFB to pause. Tap the MFB again to resume playing.

Multi-Device Connection

Follow the pairing procedure to connect the headset to Phone 1. Once connected, disconnect the headset from Phone 1 using Phone 1 ‘s Bluetooth® connection settings. Upon disconnecting, you will hear the disconnect audio prompt in the earbuds.
Activate the Bluetooth® function of Phone2 and select EHX Sport Buds 2 from the devices list to connect.
While connected to Phone 2, go back to Phone 1 and select EHX Sport Buds 2 from the devices list to complete multi-device connections.|

Multiple Call Handling

If you are on a call and receive a 2nd call, single tap the MFB to answer the 2nd call and hang up the 1st call. Double-tap the MFB to answer the 2nd call and put the 1st call on hold. You can switch between the two calls by double tapping the MFB. A single tap on ether call will end that call and go back to the other call.

FAQ/Troubleshooting

Q : I have established a connection with my smartphone, but I am not hearing any sound.
A:. Please check the volume on both devices. Some smartphones require you to setup your Bluetooth® headset as an audio output device before sound is transmitted. Please see the instructions of your smartphone for details. If you are using a music player or another Bluetooth® device, make sure it supports the A2DP stereo music profile.
Q : Why is the connection unstable, and cutting out intermittently?
A : Please make sure there is no nearby WIFI, radio, or other source of interference between the headset and the Bluetooth® device.
Q : can I use the headset while~ charging?
A: No, you cannot use the headset while it is charging.
Q : Why is the headset not responding?
A : Please try to reset the headset. See Reset section on page 4.
Q : Why is the sound not very clear?
A: Please adjust the volume on your device and/or headset Make sure there is no source of interference nearby. Remain in proximity with your device.

Tips

Please read the manual carefully before using the headset and keep ~ for future reference.
The headset needs to be fully charged prior to first-time use.
Recharge the headset inflect unused for over two weeks.
Only use chargers made by a qualified manufacturer.
tithe headset cannot be located by your device, check whether it is in pairing mode – LED at front of Right earbud blinks red and blue. If left unconnected for over 2 minutes, the headset will exit pairing mode and must be power cycled to re-enter pairing mode. If a pairing or connection issue occurs with the headset and/or device, then reboot and/or reset each device, as appropriate.

Warranty Information

Please register online at: www.ehx.com/product- registration or complete and return the enclosed warranty card win 10 days of purchase. Electro-Harmonic will repair or replace, at its discretion, a product that fails to operate due to defects in materials or workmanship for a period of one year from date of purchase. This applies only to original purchasers who have bought their product from an authorized Electro-Harmonic retailer. Repaired or replaced un~ will then be warranted for the unexpired portion of the original warranty term.

if you should need to return your unit for service within the warranty period, please contact the appropriate office listed below. Customers outside the regions listed below, please contact EHX Customer Service for information on warranty repairs at info@ehx.com or + 1-718-937-8300. USA and Canadian customers: please obtain a Return Authorization Number (RA#) from EHX Customer Service before returning your product Include with your returned unit, a written description of the problem as well as your name, address, telephone number, e-mail address, RA# and a copy of your receipt clearly showing the purchase date.

UnltedStates &Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
47-50 33RD STREET
LONGISLANDCITY,NY 11101
Tel:718-937-8300
Email: info@ehx.com

Europe
JOHNWILUAMS
ELECTRO-HARMONIXUK
13CWMDONKINTERRACE
SWANSEASA20RQ
UNITED KINGDOM
Tel:+441792473258
Email: electroharmonixuk@virginmedia.com

Warnings

Contains small parts which may be a choking hazard. ot suitable for children under age three
Set a low volume setting before using the headset
Long-term exposure to loud music or sounds may cause hearing damage. It is best to avoid high volume levels when using the headset. especially for extended periods.
Using the headset limits your ability to hear noises around you, regardless of listening volume. Please use caution when using this headset
Do not use the headset when operating a motor vehicle, a bicycle, or machinery; or where your inability to hear outside sounds may present a danger to you or others.
Check and obey applicable laws and regulations in your jurisdiction on the use of a headset when operating a vehicle.
Stop using the headset if you find its operation disruptive or distracting while operating any type of vehicle or performing any actMty that requires your full attention.
Do not drop or sit on the headset or allow the headset or earpieces to be immersed in water
Do not use the headset if one or both of the earpieces is damaged.
Keep away from fire, water, and high voltage equipment.
Do not modify, disassemble, open, crush, puncture, or shred the headset
Do not expose the headset to extreme temperatures (below OC/32F or above 45C/113F).
Do not attempt to replace the battery In the headset-you may damage the battery, which could cause overheating and injury.
Do not short-circuit the batteries.
In the event of a battery cell leaking, do not allow the liquid to come in contact with the skin or eyes.
Avoid prolonged contact with the USB cable. Do not sit on or sleep with the USB cable or put it under a blanket when it is in use.
The headset contains components that emit electromagnetic fields. They also contain magnets. These electromagnetic fields and magnets may interfere with pace makers, defibrillators, or other medical devices.
Maintain a safe distance of separation between your medical device and the headsetConsult your physician and medical device manufacturer for information specific to your medical device. Stop using the headset if you suspect it is interfering with a medical device
Earbuds can lead to ear infections if not properly cleaned. Oean the earbuds regularly with a soft lint-free cloth. Don’t get moisture in any openings, or use aerosol sprays, solvents, or abrasives.
aft skin problem develops, discontinue use. tithe problem persists, consult a physician.
When using the headset in areas where the air is very dry, it is easy to build up static electricity and possible for your ears to receive a small electrostatic discharge from the headset To minimize the risk of electrostatic discharge, avoid using the headset in extremely dry environments, or touch a grounded unpainted metal object before using the headset.
Do not use the headset during a thunderstorm as it could malfi.Jnction and increase risk of electric shock.
Keep the headset dry.

Basic Specifications

Playtime: 9·12hrs.
Recharge time: ~2 hr.
Operational frequency band: 2.4 GHz
Max. transmitted power in operational band: 10 dBm
Operation range: 10m 132ft
Battery type: Lithium – Polymer
Bluetooth® Version: VS.
Standby Time: “‘350 hrs.
Wireless Profiles: A2DP/AVCTP/AVDTP/AVRCP/HFP/SMP/SPP
Chfpset JL 6956A
Charging Voltage: DC 5V
Talking Time: “’10 hrs.

Note: Play/talking time varies according to volume and audio content

Notices

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ live technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions: ( 1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canadian Compliance:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’emetteur/receptor exempt de license contend dams le present apparel Est conformed aux CNR d’lnnovation, Sciences et Development e<:Domonique Canada applicable aux apparels radio exempts de license. L’exploitation Est authorize aux due conditions savants: (1) L’ apparel ne droit pas procure de brouillage; (2) L’ apparel droit accepter tout bromate radicle>electrique sub, meme is le brouiUage Est susceptible d’ an compromitted le fonctionnement
Bluetooth® Industry Canada Statement This Class B device meets all requirements of the Canadian interference-causing equipment regulations.
Cat apparel numerique de la Class B respected tout as les exigence’s du Regalements sur le materiel broiler du Canada. Industry Canada Statement CAN ICES.3 (B)NMB•3(B)

EU Compliance Statement:
EHX SPORT BUDS 2 (UPC 683274031095) Is in conformity with EU Directive 2014/53 and applicable harmonized standards. A full copy of the Deal a ration of Conformity can be found at wwwehx.com.
For further Information, contact Electro-Harmon, per the warranty information.

Disposal:
This symbol indicates that this product shall not be treated as household waste. Instead it shall be disposed in accordance with local environmental laws and guidelines and, where as appropriate, handed over to the applicable collection point for the recycling of electrical and electronic equipment This product was produced after Jan 12006.

TM Notices:
Bluetooth® is a registered trademark of Bluetooth SIG, Inc. Siri® is a registered trademark of Apple Inc.

WIRELESS EARBUDS
Model: EHX SPORT BUDS 2
Power Rating: 5V 1A

Shenzhen Wow Strong Technology Co., Ltd A
47th Floor, Sag Plaza, Fustian,
Shenzhen, GD, China

Made In China