hama 223582 Radio Controlled Socket Instruction Manual
- June 9, 2024
- Hama
Table of Contents
hama 223582 Radio Controlled Socket
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely.
Please keep these instructions in a safe place for future reference. If you
sell the device, please pass these operating instructions on to the new owner.
Package Contents
- 433 MHz radio-controlled socket
- These operating instructions
Safety Notes
- Do not connect units in series
- Do not cover when in use
- There is voltage running through the socket unless it is unplugged
- Only switch on and use with the safety covers closed
- Do not use the radio-controlled socket if there is visible damage to the housing
- Repair work may only be performed by qualified experts or a specialist retailer
- The radio-controlled socket meets the requirements for the IP 44 rating, meaning it is splash-proof and is suitable for outdoor use. Water jets should not be aimed at the product (e.g. a garden hose or other irrigation systems)! Operate the product either indoors or in protected outdoor areas (e.g. below eaves/roof overhang, in a garage, etc.). Protect the product from rain. Otherwise there is a risk of a life-threatening electric shock!
- Never connect the radio-controlled socket to an extension cable or adapter. It must be plugged directly into a mains socket. Connecting the timer in any other way may cause it to overheat.
- Use the timer switch only in permanent wall sockets.
- Do not operate the product outside the power limits given in the specifications.
- Disconnect from the mains before cleaning the device.
- Do not use this product with any devices that are motorized or any devices that have a rotating component or workpiece. There is a risk of injury.
Connecting and getting started
Note
On extending Hama radio-controlled socket sets. It cannot be guaranteed that
radio remote controls of other manufacturers will work.
Plug the radio-controlled socket into an outdoor earthed socket.
To test the radio-controlled socket and for manual use without a remote
control, press the “On/Off” button. When the button is pressed, the LED of the
radio-controlled socket should light up. When you press the button again, the
LED should go out. Next plug the IP44 mains plug of the electrical device you
wish to connect into the earthed socket of the timer.
The product may only be used indoors or in protected outdoor areas (e.g. below
eaves/roof overhang, in a garage, etc.).
Learn function of the radio-controlled socket
Press and hold the “LEARN” button for approx.
3 seconds until the LED starts to flash. Then select the desired channel by
pressing the corresponding “ON” button.
The LED on the radio-controlled will stop blinking when it has successfully
learnt the frequency.
If the learning is unsuccessful, the remote control socket will leave learn
mode after 15 seconds. In this case, repeat the process. It is also possible
to assign a channel multiple times (multiple radio-controlled sockets can
respond to the same remote control button).
If you wish to delete a programmed channel, first press the “LEARN” button
until the LED flashes. Press the “OFF” button for the channel to remove its
programming.
Troubleshooting
-
Remote control does not work
Check whether the battery has been inserted with the poles facing the proper directions. You can check this by making sure that the label on the battery corresponds to the polarity marked inside the battery compartment.
If the control LED on the remote control does not light up when you press a button, even when the battery has been inserted correctly, then it is possible that the remote control has a technical defect. If this is the case, please contact our customer service team or the retailer where you purchased this product. -
The radio-controlled socket cannot be switched on or off even though the remote control is working properly
Repeat the steps above under “Learn function of the radio-controlled socket” and, if necessary, contact Hama technical support or the retailer where you purchased this product.
Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.
Service and Support
Please contact Hama Product Consulting if you have any questions about this
product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here:
www.hama.com
Technical Data
| Input voltage | 250 V~/50 Hz/16 A |
|---|---|
| Output voltage | 250 V~/50 Hz/16 A |
| Maximum connection power | 16 (2) A, 3680 W; |
i.e. up to 16 A for resistive loads and up to 2 A for inductive loads
Signal frequency| 433.92 MHz
Transmitter duty cycle| < 10 %
Receivers category| Class 3
Declaration of Conformity
Hereby, Hama GmbH & Co KG declares that the radio equipment type [00223582] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.hama.com -> 00223582 -> Downloads.
Hama GmbH & Co KG 86652 Monheim / Germany
Service & Support
www.hama.com
+49 9091 502-0
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>