REMINGTON PF7855 Virtually Indestructible Foil Shaver Instruction Manual

: June 2, 2024
: Remington

REMINGTON PF7855 Virtually Indestructible Foil Shaver

Thank you for buying your new Remington® product. Please read these instructions

carefully and keep them safe. Remove all packaging before use.

IMPORTANT SAFEGUARDS

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of SE children under 8 years.
Suitable for use in a bath or shower
Do not use the product with a damaged cord. · The battery in this device is not replaceable.
Do not use the appliance if it is damaged or malfunctions.
Do not use attachments other than those we supply.
This appliance should never be left unattended when plugged into a power outlet, except when charging
Keep the power plug and cord away from heated surfaces.
Do not plug or unplug the appliance with wet hands
Do not twist or kink the cable, or wrap it round the appliance.
This appliance is not intended for commercial or salon use

PARTS

On/off switch
Intercept trimmer
Shaving foils
Hair pocket
Charging indicator
Charger connector
Pop-up trimmer (on back)
Foil assembly release buttons

Not shown:

USB cable
Stubble head guard

GETTING STARTED

CHARGING YOUR APPLIANCE

It is recommended to fully charge your product before using for the first time. · Ensure the product is switched off.
Connect the product to the USB cable and then to the USB end of the cable to a powered USB port.
Run time from fully charged is up to 60 mins.
Charge time from empty is 90 minutes.
Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.

QUICK CHARGE

Quick charge feature: Your shaver is fitted with a 5 minute quick charge feature that will provide enough charge for 1 shave (3 minutes).

INSTRUCTIONS FOR USE

It is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system. SHAVING

Switch the shaver on by pressing the On/Off button.
Stretch the skin with your free hand so the hairs stand upright.
Hold the shaving head so that the foils touch your face. 4. Use short, linear strokes.

SHAVING WITH SHAVING GEL

Follow the same instructions as dry shaving if using shaving gel.
After use with shaving gel, please ensure the head and cutters are rinsed under warm water to clean away any excess gel and debris

TRIMMING

Push the trimmer release button up to activate the trimmer.
Hold the trimmer at a right angle to your skin.
To retract the trimmer, slide the trimmer release button down and push the back of the trimmer head downwards until it locks into place.

STUBBLE LOOK

Fit the stubble head guard to your shaver for a 3-day stubble look.

TIPS FOR BEST RESULTS

Always hold the shaver at right angles to the skin so that all foils are touching the skin with equal pressure.
Use moderate to slow stroking movements. The use of short linear motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
DO NOT press hard against the skin in order to avoid damage to the foil heads.
Note: your shaver has been designed to be used in the shower if desired.

CARE FOR YOUR SHAVER

Care for your appliance to ensure a long lasting performance.
We recommend you clean your product after each use.
The easiest and most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water.
Keep the switch in the “off” position when not in use.

CLEANING CAUTIONS

Remove the foil assembly by pressing the release buttons on either side of the head and lifting the foil assembly upwards to remove from the hair pocket.
Tap out the excess hair shavings and rinse the foils under running water.
Do not clean the shaving foil with a brush.
Replace the head assembly by placing the assembly on top of the hair pocket, press down and click into place.

CLEANING TRIMMER

Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.

REPLACING THE FOILS AND CUTTERS

To ensure continued high quality performance from your shaver, we recommend the foils and cutters are replaced every six months.

SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING.

Irritation: as foils get worn, you may experience skin irritation.
Pulling: as the cutters wear, your shave may not feel as close and you may feel the cutter pulling your hair.
Wear through: you may notice that the cutters have worn through the foils.

TO REPLACE THE FOIL:

Grasp the shaver head on each side and pull it upwards.
Insert the new foil assembly on the hair pocket, press down and click into place.

REPLACING THE CUTTERS

Grasp the cutter between your thumb and forefinger and pull upwards.
Snap the new cutter into the oscillator tip.
Note: DO NOT press on the cutter ends as this may cause damage.
Foil head replacements can be found on the Remington website

TROUBLESHOOTING

If your shaver battery is completely empty or the shaver has not been used for an extended period of time, the shaver may not start when operated using the cord. If this occurs, a 5 minute quick charge will allow for 3 minutes of shaving.

BATTERY REMOVAL

We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case, and tools have sharp edges and may cause injury if not handled correctly.

The rechargeable battery must be removed from the appliance before it is scrapped.
Disconnect the charging adapter before removing the battery.

Remove Philips head screw at the base of the shaver.
Pry the outer sleeve down off the shaver handle.
Pry the back housing cover off the shaver.
Remove screws from inner housing and open inner housing to expose the batteries.
Cut the wire connecting the batteries to the circuit board and remove the batteries.
● The battery is to be disposed of safely

RECYCLING

To avoid environmental and health problems due to hazardous substances, appliances and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/ collection point.