FLASHFORGE P01 Adventurer 4 Series 3D Printer User Guide
- June 3, 2024
- FLASHFORGE
Table of Contents
FLASHFORGE P01 Adventurer 4 Series 3D Printer
Adventurer 4 Series Quick Start Guide
Component Introduction
- Power switch
- Power socket
- Filament cover
- Spool holder
- Filament intake cover
- Front cover
- Platform base
- Build plate
- Touch screen
- USB
- Ethernet input
- Extruder
- Filament guide tube joint
- Cable slot
- Fan for cooling model
- Fan for cooling extruder
- Buckle
- Air duct
- Nozzle
- Camera(AD4)
- Air filter(AD4)
Adventurer 4 lite features a glass platform with no camera and no air filter.
Packing Specification
-
3D Printer
-
Filament
-
Power Cable
-
After-Sales Service Card
-
Quick Start Guide
-
0.4-265 Nozzle （AD4 Equipped）
-
Screwdriver
-
Unclogging Pin Tool
-
Allen Wrench
-
Grease
-
USB Disk (AD4 Equipped)
-
Leveling Card
-
Filament Guide Tube Joint
-
Scraper (AD4 Lite Equipped)
-
Glue (AD4 Lite Equipped)
Software Installation
Find the Flash Print installation package in the USB disk and select the version corresponding to your system to install. Or you can download it from https://www.flashforge.com/download-center.
Preparation of Device
The equipment has been leveled and calibrated before delivery, but due to
transportation or other influences, the distance between nozzle and platform
may change. It is recommended to conduct [Calibration] after unpacking.
This step is optional, please refer to the interface function introduction
before operation.
-
Connect to power.
Connect cable to printer; turn on the switch, the screen lights up.
-
Load Filament: open the filament cover on the right side, insert the filament into the filament intake, push filament into the feeding wheel until some resistance is felt. Please make sure filaments are in the feeding wheel. Tap [Prepare]-[Filament]-[Load]. Follow the instruction, filament coming out of the nozzle indicates a success.
Note When the user wants to use the browser to view images, the printer and PC must be in an intranet (that is, the printer and PC connect to the same router).
-
Model File Transfer
Method 1: Wi-Fi Connection
Tap [Settings]-[Network]-[WIFI], operate according to the instruction. Open FlashPrint, click [Print], then click [Machine Type], select [FlashForge Adventurer 4 / 4 Lite]. You can try to enter the IP address or scan it automatically. The IP address can be viewed in [settings] – [about].
Import stl or obj file into the slicer; after slicing, the printer will heat up and start printing automatically.
Method 2: USB Device
Files can be read in USB disk. Insert USB disk and select the files to print. -
Model Removal
Adventurer 4: Take out the removable build plate, and bend the plate to get the model
Adventurer 4 Lite : Use the Scraper to take out the model
Note Nozzle and build plate are still hot after finishing printing, please
wait for them to cool down before you operate.
It is recommended to take the plate to the outside of the equipment for model
removal, otherwise the model debris will remain in the equipment. Please keep
the inside of the printer clean.
Customer Support
Zhejiang Flashforge 3D Technology Co., Ltd.
Address: No.518 XianYuan Road, Jinhua City,Zhejiang Province, China
Service Hotline: +86 579 82273989
[email protected]
