ELPRO Technologies 415U-Ex-Cx Wireless Mesh Modem and Gateway Installation Guide
- June 3, 2024
- ELPRO Technologies
Table of Contents
ELPRO Technologies 415U-Ex-Cx Wireless Mesh Modem and Gateway
Models
- 415U-E-C1 – 148 to 174MHz
- 415U-E-C3 – 360 to 400MHz
- 415U-E-C4 – 480 to 480MHz
- 415U-E-C5 – 470 to 520MHz
- 415U-E-C9 – 928 to 960MHz
Antenna installation
When selecting an antenna, consider radio proximity.
Use Figure 1 as a guide for installing an antenna and attaching it to the
415U-E-Cx.
Figure 1. Antenna installation
Connecting to the module for configuration
- Download and install configuration application “CConfig” from ELPRO website www.elpro.com.au
- Connect to PC using supplied USB cable
- Connect to the device at 192.168.111.1
- The PC will be automatically assigned an IP address via DHCP
- Username: user
- Password: user
NOTE
All connections must be SELV <50 Vac and <60 Vdc.
The following illustrations show the ports on the 415U-E-Cx.
Power supply wiring
The ground (GND) and “SUP –“ terminals are connected internally to the ground
terminal and to the module enclosure.
Connect the screw terminal on the end plate to ground for surge protection.
Refer to user manual for RF duty cycle derating when powering the module from
SUP+ and SUP- terminals.
Expansion I/O power and RS‑485 serial connection
An on-board RS-485 terminating resistor provides line termination for long
runs.
Enable terminating resistors at far end of the RS-485 cable.
Configuration switches
Use the DIP switches in the side access panel to select default configuration settings.
DIP DESCRIPTION
- Unused
- Enables default configuration
Input and output connections
The digital input/output channels can be wired as inputs or outputs.
High speed pulsed input
Digital input
Digital output
ELPRO Technologies
29 Lathe St
Virginia, QLD 4014
Australia
www.elprotech.com
Telephone:
Global: +61 7 3352 8600
ELPRO Technologies Inc
2028 East Ben White Blvd,
240-5656 Austin, TX 78741-6931
USA
Telephone:
USA: +1 855 443 5776