S H Figuarts 2623107 NFC RW Built-in Toy Instruction Manual
- June 3, 2024
- S H Figuarts
Table of Contents
S H Figuarts 2623107 NFC RW Built-in Toy
HAND PARTS
DISCLAIMER
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits tor a Class B digital device, pursuant to Part 15 of the FCC Rules. Ihese limits are designed to provide reasonable protection against harmtul interterence in a residential installation. This equipment generates uses and can radiate radio frequency energy and, f not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not OCCur in a particular installation. If this equipment does cause harmful interterence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interterence by one or more of the following measures- Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio IV/ technician for help. Shielded cables must be used with this unit to ensure compliance With the Class B FCC limits. This device complies with Part 15 of the FCC Rules. 0peration is subject to the following two conditions: this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3(BNMB-3(B).
CAUTION
for ages 15 and up.
- Please handle with care and store out of the reach of children younger than 15 years old.
- This product contain small parts/small ball parts. Not for children younger than 15 years old.
- This product may contain parts that have sharp points and edges. Please handle it carefully to avoid getting injured.
- Do not place this product on top of plastic furniture., sofa, sheet, tile or anything made of resin. t may cause color migration.
- Color. stvle and decoration may vary.
HEAD PARTS
BODY ASSEMBLY
BASE for DRAGON BALLS
- Remove the Battery cover by sliding the Battery cover while pressing the release button with a thin stick.
- Set 3 AA/R6 batteries.
- Replace the Battery cover.
POSITION
-
Place a DRAGON BALL on the BASEs dent with the star mark facing up. The DRAGON BALL elows when placed correctly.
When finished placing 7 DRAGON BALLS, they glow once again at the same time. -
Place DENDE on the designated position. If successful, you hear DENDE’s spel to summon PORUNGA.
*Press the Function button does the same effect without placing DENDE -
You hear PORUNGA summon sound effect and the voices when pressing Function button or a certain period of time elapses.
-
PORUNGA asks for your wish, so think about your wish and press the Function button. Then, PORUNGA makes a reply to your wish, you will repeat this 3 times.
-
Move DENDE away from the BASE at least 10cm, and put DENDE back on the BASE, that is the same effect as pressing the Function button.
- There are several variations for PORUNGA’s replies, including denying8.
- PORUNGA or DENDE requests you to make a wish when not pressins the Function button.
- PORUNGA’S replies do not guarantee your wishes will be granted in the future.
- BAfter the 3rd wish, it ends with the sound effect of PORUNGA disappearing.
-
it also ends if you do not press the Function button.
-
You can start again by pressing the Function button after the end, if the Power switch is not turned OFF.
CAUTION
if there is metal near the BASE for DRAGON BALLS or the table on which Base is placed is made of metal, maltunction may OCCur. If this case, please change the locatlon and try again.