STEALTH High Wall Ductless Air Conditioning and Heating System Remote User Guide
- June 3, 2024
- STEALTH
Table of Contents
STEALTH High Wall Ductless Air Conditioning and Heating System Remote
QUICK-START
HIGH-WALL DUCTLESS AIR CONDITIONING &HEATING SYSTEM
| Press to power the unit on or off.
---|---
| Press to select fan speed (Auto, Low, Medium, High or Turbo). Auto is
default.
| HEAT
DRY
AUTO
COOL
FAN ONLY
| Press to raise settings including temperature and time.
| Press to control vertical angle of louvers and to redirect airflow.
| Press to boost cooling or heating airflow. Quickest way to reach preset
temperature.
| Press to lower settings including temperature and time.
| Press to select temperature display: indoor, outdoor or desired room
temperature (Adjust desired temperature with and buttons.)
| Press to select one of three SLEEP modes, each offering varying levels of
comfort control while sleeping. See Owner’s Manual for more details.
| Press to activate; allows unit to sense temperature at the remote
controller.
| Press to display time of day.
| Press to turn on lights on the unit’s Front Panel Display. Press again to
turn off
| Press to start or stop the timer. (Adjust with and buttons.) See Owner’s
Manual for more details.
INDOOR UNIT FRONT PANEL DISPLAY: Look here for LED display of system status,
setpoint, indoor and outdoor temperatures and malfunction codes.
KEY FEATURES & FUNCTIONS
MULTI FAN SPEEDS
Whether operating in either Cooling or Heating mode, the indoor fan can be set
to your choice of four different speeds (Low, Medium, High or Turbo) to
achieve maximum comfort.
DRY MODE
During warm, humid conditions, selecting this mode will help to increase
moisture removal in your room for added indoor comfort. Fan speed cannot be
adjusted in Dry Mode.
FREEZE GUARD MODE
This “vacation mode” feature offers protection against potential water pipe
freeze up while away from home. It automatically keeps room temperature from
getting too cold.
INTELLIGENT DEFROST
This increases room comfort and saves energy by sensing the need for
defrosting and eliminating unnecessary defrost cycles.
POWER FAILURE MODE
Your settings and parameters are stored in non-volatile memory and are
retained during a power failure.
I FEEL MODE
This function senses the temperature at the remote controller instead of at
the indoor unit. It then adjusts airflow and temperature accordingly for the
ultimate in personal comfort control and energy savings.
SLEEP MODE
You design a cycle to automatically adjust room temperatures during your sleep
time, to maximize comfort and reduce utility bills
INTELLIGENT PRE-HEATING
In heating mode, the system delays fan activation until the coil has warmed
up, to prevent blowing uncomfortable cool air into the room.
SELF-DIAGNOSIS
The built-in computer uses real-time diagnostics to continuously scan for
errors or malfunctions. Fault codes are shown on the unit display to
facilitate troubleshooting.
POLYMERIC AIR FILTER
Saves energy by preventing indoor coils from being plugged with dirt and lint.
May be washed, vacuumed and reused.
FAQs
Why does the fan continue to run even when the unit is not cooling or heating?
Why does the fan continue to run even when the unit is not cooling or heating?
To maintain consistent temperatures and minimize energy-loss from constant
starts and stops, the fan keeps air flowing past the thermostat
What temperature is displayed on the remote controller?
What temperature is displayed on the remote controller?
The remote always displays your desired indoor temperature. (You may view
current indoor and outdoor temperatures, as well as desired temperature, on
the indoor unit’s Front Panel Display.)
What happens if the remote is lost or damaged?
Use the Aux button to manually operate the unit. Lift up the front panel
section on the indoor unit and locate the button on the right-hand side.
Press the button to turn the unit ON or OFF. (Not all functions will be
available.) Press again to cancel Aux Mode and transfer control back to the
remote controller