velleman K8007 Dimmer Module User Manual
- June 3, 2024
- Velleman
Table of Contents
velleman K8007 Dimmer Module
Features
- Easy pushbutton up/down control of light sources
- A brief push toggles on/off, while continued pushing engages dimming action
- Memory function maintains preferred level
- Soft start function
- Suitable for low voltage halogen lighting
- For use with K8006 Base unit for home modular light system
Specifications
- Operating voltages : 110-125 or 220-240VAC 50/60Hz
- Max. load : 2.5A (550W/220V; 275W/110V)
- Transient suppressor to avoid radio/TV interference
- Dimming speed : approx. 3.5s
- Dimensions pcb (wxdxh): 65 x 57 x 25mm
modifications reserved
Assembly
Ok, so we have your attention. These hints will help you to make this project
suc-cessful.
Read them carefully.
Make sure you have the right tools:
- A good quality soldering iron (25-40W) with a small tip.
- Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look. This is called ‘thinning’ and will protect the tip, and en-ables you to make good connections. When solder rolls off the tip, it needs cleaning.
- Thin raisin-core solder. Do not use any flux or grease.
- A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they cannot fly towards the eyes.
- Needle nose pliers, for bending leads, or to hold components in place.
- Small blade and phillips screwdrivers. A basic range is fine.
For some projects, a basic multi-meter is required, or might be handy
Assembly Hints :
-
Make sure the skill level matches your experience, to avoid disappointments. þ Follow the instructions carefully. Read and understand the entire step before
you perform each operation. -
Perform the assembly in the correct order as stated in this manual
-
Position all parts on the PCB (Printed Circuit Board) as shown on the drawings. þ Values on the circuit diagram are subject to changes.
-
Values in this assembly guide are correct*
-
Use the check-boxes to mark your progress.
-
Please read the included information on safety and customer service
-
- Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaflet.
-
1.3 Soldering Hints :
AXIAL COMPONENTS ARE TAPED IN THE CORRECT MOUNTING SEQUENCE
TESTING
For the hook-up diagram and the test procedure, please turn to the illustrated part list of the K8006, Base unit for home modular light system (H8006P), section 12.
PCB LAYOUT
DIAGRAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>